Instruction for Use

ManualsBrandsKitchenAid ManualsDomestic AppliancesKDSCM 82141

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid

dispenser A should be filled when the RINSE AID

REFILL indicator light in the control panel is lit.

1. Open the dispenser B by pressing and pulling up

the tab on the lid.

2. Carefully introduce the rinse aid as far as the

maximum (110 ml) reference notch of the filling

space - avoid spilling it. If this happens, clean the

spill immediately with a dry cloth.

3. Press the lid down until you hear a click to close it.

NEVER pour the rinse aid directly into the tub.

ADJUSTING THE DOSAGE OF RINSE AID

If you are not completely satisfied with the drying re-

sults, you can adjust the quantity of rinse aid used.

• Switch the dishwasher on using the ON/OFF

button.

• Switch it off using the ON/OFF button.

• Press button P three times - a beep will be heard.

• Switch it on using the ON/OFF button.

• The current selection level number and rinse aid

indicator light flash.

• Press button P to select the level of rinse aid

quantity to be supplied.

• Switch it off using the ON/OFF button

Setting is complete!

If the rinse aid level is set to ZERO (ECO), no rinse

aid will be supplied. The LOW RINSE AID indicator

light will not be lit if you run out of rinse aid.

A maximum of 4 levels can be set according to the

dishwasher model. The factory setting is for a medi-

um level.

• If you see bluish streaks on the dishes, set a low

number (1-2).

• If there are drops of water or limescale marks on

the dishes, set a high number (3-4).

FILLING THE DETERGENT DISPENSER

Only use detergent which has been specifically de-

signed for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam res-

idues remaining in the machine after the cycle has

ended.

To achieve the best washing and drying results, the

combined use of detergent, rinse aid liquid and re-

fined salt is required.

We recommend using detergents that do not contain

phosphates or chlorine, as these products are harmful

to the environment.

Good washing results also depend on the correct

amount of detergent being used. Exceeding the stated

amount does not result in a more effective wash and

increases environmental pollution.

The amount can be adjusted to the soil level.

In the case of normally soiled items, use approxi-

mately either 35g (powder detergent) or 35ml (liquid

detergent) and additional tea spoon of detergent di-

rectly inside the tub. If tablets are used, one tablet

will be enough.

If the crockery is only lightly soiled or if it has been

rinsed with water before being placed in the dish-

washer, reduce the amount of detergent used accord-

ingly (minimum 25 g/ml) e.g. skip the powder/gel

putted inside the tub.

For good washing results also follow the instructions

shown on the detergent box.

For further questions please ask the detergent producers.

To open the detergent dispenser press button A.

Introduce the detergent into the dry dispenser B

only.

Place the amount of detergent for pre-washing di-

rectly inside the tub.

1. When measuring out the detergent refer to the

mentioned earlier information to add the proper

quantity. Inside the dispenser B there are

indications to help the detergent dosing.

2. Remove detergent residues from the edges of the

dispenser and close the cover until it clicks.

3. Close the lid of the detergent dispenser by pulling

it up until the closing device is secured in place.

The detergent dispenser automatically opens up at

the right time according to the program.

If all-in-one detergents are used, we recommend us-

ing the TABLET button, because it adjusts the pro-

gram so that the best washing and drying results are

always achieved.