Manual

Lowerjets Clean pans casseroles etc. with Tough Activates the 75 90 0_1:5
ProScrub toughfoodsoilto eliminatethe needfor Normal ProScrub® spray jets (0' 5 7)
soaking and Sciubbing 0f dirtY' baked -0n Dr0WashTM to provide intensified i
d shesl " c ean ng p0wer t0
Raises the main wash temperature to Tough Raises the main 40 50 0 - 1.5
Hi-Temp improve cleaning for loads containing tough, Normal wash temperate (0 - 5.7)
Wash baked-on food. ProWashT M from 105°F (41°C) to
SoundOn/Off either 130°F (55°C)
Hold 3 Sec or 140°F (60°C).
sanitizes dishes and glassware in Tough increases the main 72 85 0
Sani accordance with NSF International NSFi Normal wash temperature (0-57)
r_i-,_ _ ANSI standard 184 for Residentia ; 'TM fr0m 105°F (41°C) t0 !
R Ilbg ..... _-rowasn o o
Dishwashers. Cerhfled resldenhal 140 F (60 C) and
dishwashers are not intended for licensed the final rinse from ................................
food establishments: The Sani indicator 1401F (60°C) to
indicates at the end of the cyc!e whether the !55°F (68tC).
Sani Rinse option was successfu!!y
completed. If the indicator isn0t activated, it
............ is probably due to the cycle being
interrupted.
Top Rack
Only
Control Lock
Hold 3 Sec
For added convenience, use for washing a
small load of dishes in the top rack to help
keep the kitchen continuously clean.
Available Slightly faster wash
with any for smaller loads
cycle
- 3 -40
Runs the dishwasher at a later time or during Available DelaYs the start of a 240 480 0
off-peak electrica! hours. Select a wash cYCle with any CYC!eto the ...................................
2.4,8 Hr, and optionsl Press the Delay button. Press cycle specified timel
NOTE: Anytime the door is opened (such as,
t0 add a dish), the StaWResume button must
be pressed again t0 resume the delay
countdown.
Top Rack
Only
Control Lock
Hold 3 Sec
Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold TOP RACK ONLY for 3 seconds. The Control Lock light will stay on for a short time, indicating that
it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked, the light flashes 3 times. The
dishwasher door can still be opened/closed while the controls are locked.
NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL/DRAIN, or by opening and closing
the door before you are able to turn Control Lock off.
To turn off Control Lock, press and hold TOP RACK ONLY for 3 seconds. The light turns off.
NOTE: If your model requires you to press and hold TOP RACK ONLY to lock the controls, the Control Lock LED will be on or off
to indicate whether Control Lock is active or not.
Start
RESUME
Repeat Last
Cycle
To start or resume a
wash cycle
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and START/RESUME is pressed.
NOTE: If the Start/Resume button is located on top of door, push door firmly closed within
3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds, the Start/
Resume button LED will flash, an audible tone will be heard, and the cycle will not start.