Installation Instructions

3
Align the studs on the custom wood panel to the keyhole
slots on the door assembly. Ensure that all 4 plastic studs are
engaged in the keyhole slots. Slide wood panel down until the
top surface of the wooden panel is ush with the top of the door.
Open the door and align top edges. Use tape to mark a 3/32"
drill bit to gauge the hole depth of approximately 1½" (38 mm).
Drill pilot holes into the top corners of the door, using hole in liner
as a guide.
5. Attach custom panel
Wooden panel
assembly
6. Align top edges of panel to door
Align top
edges
Remove 2 short screws
and replace with long
screws provided
Customer
supplied
panel
1½"
Using a Torx T15 screwdriver, install two #8 x 1/
8
" (long) screws
in top corners to secure custom wood panel in place.
Remove the short screws (4
th
from top) on either side of the inner
door panel. Use tape to mark a 3/32" drill bit to gauge the hole
depth of approximately 1½" (38 mm). Drill 2 pilot holes using the
door liner hole as a guide into the panel. Install the 2 remaining
long screws.
Customer
supplied
panel
Drill through
this hole
Align top
edges
1/
8
"
screw
7. Install custom panel
Remove 2 short screws
and replace with long
screws provided.
Customer
supplied
panel
Align top
edges
8. Remove the short screws
Vent duct on
applicable models
only