Safety and Installation Instructions

6
Ground
wire
Ground
screw
Washer
Ground connector
screw
White wire
White wire
Black wire
Black wire
Ground wire
Terminal
box cover
4. Connect ground wire
Route power cord through strain relief in the back of the terminal
box. Remove the ground connector screw on the raised oor
inside the box and place it through the ring terminal of the green
ground wire of power cord. If wire has no ring terminal, bend
a loop in the end of the wire. Reattach and tighten the ground
connector screw to the raised oor of the box.
5. Connect remaining wires
To connect wires with ring terminals, remove the screws from the
terminal block, place the screw through the ring terminals, and
reattach screws back into the terminal block.
To connect wires without ring terminals, remove the screws from
the terminal block. Bend a loop in the end of the wires. Push the
screws through the loop. Return the screws to the terminal block.
Tighten the screws.
NOTE: Pre-tinned wires should not be used when connecting to
the terminal block.
Wiring conguration
6. Secure cord or wire in strain relief
Tighten strain relief screws to secure cord.
7. Reinstall terminal box cover and wires
Place wires inside terminal box. Replace the cover by inserting
the hooks of the terminal cover into the slots in the oor of the
terminal box and sliding the cover tight against the back wall
where wires come in. Make sure wires are tucked inside the box
and not pinched by the cover. Put the terminal box back on the
crossbar and push to the right so terminal box snaps into the
plastic side member.
NOTES:
■ Do not plug cord into an outlet until instructed to do so.
■ Once the terminal box has been remounted on the dishwasher,
tuck any excess length or slack over nearby components to
help keep them off the oor.
■ Route cord out the rear of the dishwasher so that it does not
touch dishwasher motor or lower part of dishwasher tub.
■ A maximum of 2 power cord supply conductors (12 AWG
largest size) plus 1 grounding conductor are permitted in the
terminal box.
IMPORTANT: No additional connections other than dishwasher
power connection are to be made inside the dishwasher terminal
box.
COMPLETE INSTALLATION
1. Reconnect oat switch
Check that the power supply wire or cord does not touch
dishwasher motor or the lower part of the dishwasher tub.
Reconnect oat switch by aligning connector removed in Step
Remove oat switch wires with the connector housing and
pushing in until the locking tab is visible over the back of the
connector.