Installation guide

SingUe oven
27-1/2"
(e&e era}
recessed
height
23"
era)
raax.
recessed
depth
DoubUe oven
25-3/5"
(54.5 crai raax.
_-----""_tecessed width_ _
49=1/2"
{125,7 era)
recessed
height
25=3/4"
era}
overall width
51"
(129.5 era)
raax.
overall
height
27=3/4"
{78.5 era)
rain,
cutout
height
27" (68.5 era} rein. ____
cabinet width
1-1/2"
(3,8 cral rain,
top of cutout
to underside
of eountertop
25ol/2" _ _-
{64,8 era) 5-1/4" (13,3 era)
cutout width bottom of cutout
to floor
T
49-3/4"
(12&4 era)
rain,
cutout
height
Singme oven 1-1/2-/3.eera}
unde rco u nter rain.bottoraof
(without cooktop cutout to top of
installed above) cabinetdoor
.___ 27"(6&ecra) __
rain, cabinet
25=1/2"
{54,8 era)
___ cutout
width
Double oven
1" (2.5 era) top
of cutout to
bottom of upper
cabinet door
14=3/4"
{37,5 era}
bottom of
cutout to Root
27" {5&6 cra)
rain,
cabinet width
t
27=314"
{7&5 era)
rain,
cutout
height
1ol/2"
(3.8 era}
rain,
bottoraof
cutoutto
top of
cabinet
door
25-1/2"
_{64.8 cra}_
cutout
width
1" (2,5 era) top
of cutout to
bottom of upper
cabinet door
32"
{51,3 era)
bottom of
cutout to
floor
Singmeoven
eabinet--_
23-1/4"
{5&1 era}rain.
cutout depth
23" (58.4 era}
_---recessed oven ----)_
depth
J
recessed
oven
Cabinet side view
_/_ oven
front
Y0nr safety and the safety of others are
very important.
We have provided many important safety
messagesin this manual and on your appliance.
Atways readand obey aii safety messages.
This is the safety alert symbot:
This symbol alertsyou to potential
hazardsthat can kill or hurt you and
others.
AIIsafety messageswilI follow the safety alert
symbol andeither the word "DANGER"or
"WARNING".Thesewords mean:
Y0ucar be killed or seriously iniured if y0u
don't f0110winstructions.
AIIsafety messageswilI teii you what the
potential hazard is, teli you how to reducethe
chanceof injury, andteti you what can happenif
the instructions are notfollowed.
important: Observe all governing codes
and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this even.
Oven location should be away from strong
draft areas, such as windows, doors and
strong heating vents.
Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed
portion of the oven.
ElectricaJ ground is required. See "Electrical
requirements."
Electrical suppJv junction box should be
located 3 inches (7.6 cm} maximum below the
support surface when oven is installed in a
wall cabinet. Drill a 1-inch minimum (2.5 cm)
diameter hole in the right rear or left rear
corner of the support surface to pass the
appliance cable through to the junction box.
For undercounter installation, it is
recommended that the junction box be
located in the adjacent right or left cabinet. If
installing the junction box on rear wall behind
oven, junction box must be recessed and
located in the upper or lower right or left
corner of cabinet.
it is the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installationis
adequate and in conformance with National
Electrical Code, ANeI/NFPA 70 _ latest
edition*, or Canadian Electrical Code, C22.1-
1982 and C22.2 No. 01982 (or latest edition)**
and nit local codes and ordinances.
Copies of the standards listed raay be obtained from:
* National Fire Protection Association
Batteryraarah Park
Quincy, Massachusetts 02259
e* CSA International
5501 East Pleasant VaHey Road
C_eveland, Ohio 44131°5575
Tool needed:
screwdriver
Parts supplied:
4 screws {double oven}
Page 1