Installation guide

COOKTOP SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER?” or “WARNING.”
These words mean:
You can be killed or seriously injured if you don't immediately
A DANG ER follow instructions.
You can be killed or seriously injured if you don't follow
A WAR | | | G instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
INSTALLATION REQUIREMENTS
Tools anc Paris
Gather the required tools and parts before starting installation. Parts needed
Read and follow the instructions provided with any tools listed m AUL listed or CSA approved strain relief for 7" (2.2 cm)
here. knockout.
Tools needed mw AUL listed or CSA approved conduit connector for
m Tape measure m Marker or pencil ve" (1.3 cm) trade-size metal-clad conduit
m Flat-blade screwdriver m Pliers m UL listed wire connectors
m Phillips head screwdriver om 14" drill bit m Metal ducting
= Drill m Jigsaw m Wall cap
w Level gw Ratchet with ¥"socket 6" (15.2 cm) Round Surface Wall Cap Damper
. Order Part Number A406
m 6" socket extension
5" (12.7 cm) Round Surface Wall Cap Damper
. Order Part Number A405
Parts supplied
m Vent grille 3%" x 10" (8.3 x 25.4 cm) Surface Wall Cap Damper
Order Part Number A403
To order, see the “Assistance or Service” section of the Use
and Care Guide.
gm Pre-filter
mg Vent clamps
Check local codes. Check existing electrical supply. See
“Electrical Requirements” section.
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.