Installation guide

Product #[mens[ens
2-15/16"
j (74.6 mml
burner box
depth
Cateut #imensiens
cm)
_pth
15-5/8" (3&6 cm)
blower housing
depth
34t. 91.4 cm long
power suppy cab e
factory installed.
Clearancegimensiens
30" (762 cm) min =3g" (7&2 cm) model
36" (91.4 cm) min =36" (gl.4 cm) model
_- wbee higher thee 18" (45.7 cm) _1
B
See Note ** [or
minimum clearaeces
b
N I
Nieiraumdistaece,i_ I. _ . , _ _\21"(5a.a cm)
to nearestoombostiNe"_\ \_, ue !.Jo_seal _.r_\ opening depth
vertical surface "..._ \ ceo,'neple ceoiHenep. -_......
extending 18" 4&7 cm) ',.,_ " " _--
above ceoktep _. ....:_. \_ ...............................................................................................................................................................................................
29=1/2" (74.9 cm) ° 30" (7&2 cm) model
354/2" (96.2 cm) =36" (91.4 cm) model
cutout width
Side clearance - 6" (15.2 cm) minimum clearance between side
of cooktop and side wall is recommended for maximum
ventilation performance.
Rear cJearance = 3/4" (19,1 mm) clearance between rear edge of
cooktop and rear wall is recommended.
Motor/blower clearance -- 2" (51 mm) minimum clearance
between motor and cabinet is required for proper cooling.
6" (15.2 cm) clearance is recommended for servicing access.
_ Note: 24" {01 era} rainiraura when bottom of wood or rectal cabinet is
protected by not less than 1/4" {0.4 rare} flarae retardant raillboard covered
with not Jessthan No. 28 MSG sheet steel, 0.015" (0.4 rare} stainless steel,
0.624" (0,0 rare} alurainura or &O20" (0,5 rare} copper,
30" {76,2 era) rainiraura cJearancebetween the top of the cooking platforra
and bottom of unprotected wood or sheet rectal,
coontertop
_estall rear
wall junction
box ie shaded
area. #arker
shaded area is
preferred.
5" (12.7 em)
I
Minimum base cabinet dimensions i
30" (76,2 cm) base cabinet width
24" (61 cm) base cabinet depth
25" (63,5 cm) countertop depth
Countertop opening dimensions that are shown must
be used, Given dimensions are minimum clearances and
provide required 0" (0 cm) clearance,
New installations i Follow minimum dimensions given,
Replacement installation i Be sure that front edge of
cooktop is at least 1=1/2" (38,1 mm) back from front
edge of countertop,
If cabinet has drawers, drawers will need to be
removed and drawer fronts installed on front of cabinet,
Cutout preparation:
Decorative laminate --
Chamfer all exposed edges to
prevent chipping laminate,
Cut radius corners and file to
smooth edges and to prevent
cracking=