Instructions for use
These instructions are also available on the website: www.kitchenaid.
Important instructions for safety unless they are supervised by adults. • Do not repair or replace any part of the appliance unless specifically indicated in the manual. Defective parts must be replaced using genuine parts. All other maintenance services must be carried out by a specialized technician. • Children must be supervised to ensure they do not play with the appliance. • When drilling through a wall or the ceiling, pay attention not to damage electric connections and/or pipes.
• For further information on the treatment, recovery and recycling of household appliances, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. Scrapping of household appliances • This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before disposing of it, make it unusable by cutting off its power supply cable.
Installation This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F 3 x 0.75 mm²) must be carried out by a qualified electrician. Contact an authorized service centre. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place.
Troubleshooting guide • Check the filters are clean; • Check the air vents are not blocked; The light does not work: • Check to see if the lamp needs replacing; • Check to see if the lamp has been fitted properly; The appliance does not work: • Check the domestic power supply and ensure the appliance is connected to the mains properly. • Switch the hood off and then on again to see if the problem has been resolved.
Maintenance WARNING: - use safety gloves. - disconnect the appliance from the mains power supply. GREASE FILTERS Captures grease particles released by the cooking process. The grease filter should be cleaned once a month, either by hand or in a dishwasher at a low temperature and on a short cycle. Cleaning in a dishwasher may cause the metal grease filter to become cloudy, but this dos not affect its filtering efficiency efficiency.
Installation - preliminary assembly instructions WARNING: - Installation or maintenance must be carried out by a qualified technician. The hood is designed for installation and use as an "Extractor version". Install the hood away from very dirty areas, windows, doors and heat sources. IMPORTANT: The hood comes with all the materials necessary for installation on the majority of ceilings.
Installation - assembly instructions WARNING: - Installation or maintenance must be carried out by a qualified technician. - Very heavy product; hood handling and installation must be carried out by at least two persons. The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual. 1. Remove the hood body from the packaging and carry out the following preliminary procedures: 1.
Description and use of the hood 1. Hood body 6 2. Extraction panel 3 3. Lighting 4. Grease filters 4 7 5. LED indicator light 1 8 6. Wall mounting. 7. Extraction panel fixing pins 5 9 8. Safety sliders 2 9. Remote control REMOTE CONTROL The remote control must be recognized by the hood through the following procedure: Hood and remote control pairing procedure Press the "◄" or "►" button until the remote control shows the symbol Press the middle button "■" for 5 seconds.
n Printed in Italy 06/15 400010803606 GB