Installation guide

Now start...
Excessive Weight Hazard
Use two or more people to move and
install range.
Failure to do so can result in back or
other injury.
1[] Remove shipping matedab, tape
and protective film from range. Keep
cardboard bottom and shipping base
under range. Remove oven racks and
parts package from inside oven.
Tip Over Hazard
A child or adult can tip the range and
be killed.
Connect anti-tip bracket to rear
range foot.
Reconnect the anti-tip bracket, if the
range is moved.
Failure to follow these instructions can
result in death or serious burns to
children and adumts.
[] Contact a qualified floor covering
installer for the best procedure for
drilling mounting hobs through your
type floor covering.
EJectricaJ connection
[] Remove the terminal block cover
screws located on the back of range, Puii
cover down and towards you to remove
cover from range,
Pull cover down
and towards you
to remove.
terminal
block cover
_2 mounting
tabs, each side
/
hex-head screws
[] Remove storage drawer. Use a 3/8"
drive ratchet to lower rear leveling legs
one-half turn. Use channel lock pliers to
lower front leveling legs one-half turn.
rear leveling leg front leveling leg
flooring, longer screws may
be necessary to anchor the bracket to the
sub°floor. Longer screws are available
from your local hardware store.
Check that range is on cardboard
shipping base to protect floor covering.
[] Depending on your electrical
supply, make the four-wire or three-wire
connection to the range following the
"Power supply cord method" or "Direct
wire method" instructions for copper
wire or aluminum wire depending on the
connection needed.