Installation guide

Operating position
Before moving range across floor, check
that range is still on cardboard shipping
base to protect floor covering.
7[] Make sure the anti-tip bracket is
installed:
Look for the anti-tip bracket securely
attached to floor.
Slide range back so rear range foot
is under anti-tip bracket.
8[] If installing the range in a mobile
home, you must secure the range to the
floor. Any method of securing the range
is adequate as long as it conforms to the
standards in the "Mobile home
installation"section.
9_ Place rack in oven. Place level on
rack, first side to side; then front to back.
If range is not level, pull range forward
until rear leveling leg is removed from
the anti4ip bracket. Use 3/8" drive ratchet
and channel lock pliers to adjust leveling
legs up or down until range is level. Push
range back into position. Check that rear
leveling leg is engaged in anti4ip
bracket.
NOTE: Oven must be level for
satisfactory baking conditions,
Replace the storage drawer or
lower panel.
1_ Reconnect power.
Check operation
2_ Check the operation of the
cooktop elements:
Push in and turn each surface unit control
knob to "Hi" position. Check the
operation of the cooktop elements and
indicator lights.
CO FRONT OFF
@O
3_ Check the operation of the
oven:
If your oven has one of the two types of
electronic controls shown:
Press the "BAKE" pad.
Depending on model, the "BAKE"
and "TEMP" indicators will light
and "350" will appear in the display
or, the "BAKE" indicator will light
and "350" will appear in the display.
2_
_The "START" indicator will begin
flashing after 5 seconds.
Press the "START/ENTER" pa&
_The "ON" indicator will light.
_The "TEMP" indicator will turn off.
*The display wiii show the automatic
countdown time needed to preheat
the oven to the selected temperature
("350") and begin counting down.
oThe bottom element should glow
red_
_The upper element should become
hot, but not glow red.
3. Press the "OFF/CANCEL' pad.
NOTE:The oven will not go through
preheat if the oven temperature is above
170 ° F; instead, the "TEMP" indicator will
light and the selected temperature will
appear in the display.
4. Press the "CUSTOM BROIL' pa&
* Depending on model, the "BROIL'
and "TEMP" indicators will light
and "500" will appear in the display
or, the "BROIL' indicator will light
and "500" will appear in the display.
_The "START" indicator will begin
flashing after 5 seconds,
5. Press the "START/ENTER" pad.
®The "ON" indicator will light.
_The upper element will glow re&
6. Press the "OFF/CANCEL' pad.
You have just finished installing
your new range.To get the
most efficient use from your
range, read your Use & Care
Guide. Keep Installation
Instructions and Guide close to
range for easy reference. The
instructions will make installing
the range in another home as
easy as the first installation.