Instruction for Use

11
10. Connect a pipe (pipe and clamps are not provided, they must be purchased separately) for fumes
exhaust to the connection ring located above the suction motor unit.
The other end of the pipe must be connected to a device for expelling the fumes outdoor in case of
use of the hood in extraction version.
If the hood is used in the filter version, then remove the fumes non-return valve “E”, fasten the
deflector “F” to the flue support bracket “G” adjusting it according to the flue width and connect the
other end of the pipe to the connection ring located on the deflector “F”.
11. Carry out the electrical connection. Position the power cable in its housing and secure the cable to
the cable clamp (11a).
12. Apply the flues and fix them with two 2 screws (12a) to the flue support bracket“G” (12b).
13. Slide the bottom section of the flue all the way over the extraction unit until it engages the seat
above the hood.
Refit the grease filter(s).
Re-fit the perimeter extraction panel
IMPORTANT: Always make sure the panel is firmly fixed in place.
Check the hood operation, referring to the hood description and use section.