Instructions for use
These instructions are also available on the website: docs.kitchenaid.
Important instructions for safety YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. • This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others. • All safety warnings are preceded by the attention symbol and the following terms: • DANGER: indicates a hazardous situation which, if not avoided, will cause serious injury.
• Never flame cook food (flambé) under the appliance. Using free flames might cause fire. • Do not leave frying pans unattended when frying, as the frying oil may catch fire. Scrapping of household appliances • This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before disposing of it, make it unusable by cutting off its power supply cable.
Installation After unpacking the appliance, check for any damage caused during transport. In case of problems, contact the dealer or the After-Sales Service. To avoid any damage, it is advisable to only remove the appliance from the polystyrene base just before installation. This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F 3 x 0.75 mm²) must be carried out by a qualified electrician. Contact an authorized service centre.
Troubleshooting guide The appliance does not work: • Check the domestic power supply and ensure the appliance is connected to the mains properly. • Switch the hood off and then on again to see if the problem has been resolved.
Maintenance WARNING: - use protective gloves. - disconnect the appliance from the mains power supply. GREASE FILTERS Metal grease filters have an unlimited life and should be washed once a month either by hand or in a dishwasher at a low temperature and with a short cycle. Washing in a dishwasher can cause grease filters to turn white, but this in no way affects efficiency. Pull out the handle to remove the filter. Wash the filter and leave it to dry, proceeding in reverse order to refit it.
Material supplied Remove all the components from the packets. Check that all the components are included. • • • • • • • • • • • Hood assembled with motor, lamps and grease filters installed. Instructions for assembly and use 1 connection ring Telescopic flues 1 Assembly template 6 wall plugs Ø 8mm 6 screws Ø 5x45 1 cable clamp Power cable 3 screws Ø 3.5 x 9.5 60, 70 and 90 cm wide models only: 1 Flue support bracket 1 baffle 4 screws Ø 2.9x6.
Installation dimensions Adjacent wall units 65 cm (gas or combi cookers) 50 cm (electric cookers) 1200 mm min (120 cm wide model) 900 mm min (90 cm wide model) 700 mm min (70 cm wide model) 600 mm min (60 cm wide model) Adjacent wall units central line cooktop surface Installation - assembly instructions The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual, that are inserted in the in
23. Fix the collar to the exhaust opening. 24. Secure the box with the screws already pre-tightened to the motor body. Note: The box is of two types, with front or rear fixing. Follow the instructions in the figures (24a and 24b), depending on your model. 25. Fit the power cable in the special housing. 26. Secure the cable to the cable clamp. IMPORTANT: This operation is compulsory. To avoid accidental disconnection of the electrical cable. Carry out the connection to the household electrical system. 27.
Description and use of hood 1. Control panel. 2. Grease filters (over the perimeter extraction panel). 3. Halogen lamps. 4. Telescopic flue. 5. Perimeter extraction panel. Control panel a. Light ON/OFF button b. Motor ON/OFF and minimum speed (extraction power) selection button c. Medium speed (extraction power) selection button d.
n Printed in Italy 07/16 400010893115 GB