Instruction Sheet
Temperature Probe Guide
■ If the temperature probe is not connected, the
mobile app will display an error message.
■ Only specic cycles can be used with the
temperature probe.
Temperature Probe Tips
■ Remove any racks above the food that are not in use.
■ Insert the probe into the food item. For meats, the probe
tip should be located in the center of the thickest part of
the meat and not into the fat or touching a bone.
■ Do not use the temperature probe on frozen food.
■ For the most accurate temperature readings, insert as
much of the probe shaft as possible into the food.
■ Place the probe into the food and then connect the
probe to the jack.
■ Keep probe as far away from the heat source as
possible.
■ Always unplug and remove the temperature probe from
oven when the cycle is complete.
Troubleshooting
■ Ensure the temperature probe is fully seated into the
jack, the range will make a tone when the probe is
inserted. See picture below for reference.
■ The temperature probe can only be used from the
mobile app.
■ Avoid removing the temperature probe once a probe
cycle has been started until the cycle has completed.
If removed, the cycle may need to be restarted to
continue.
■ Ensure that the mobile app is using the latest version
available. If problems persist, try reinstalling the mobile
app.
Using the Temperature Probe
1. Connect your appliance. The temperature probe will only
work when the appliance is registered in the mobile app
listed on your Quick Reference Guide and linked to your
Wi-Fi.
2.
Insert the temperature probe into the food. See
“Temperature Probe Tips” for more information.
3.
Insert the temperature probe into the jack, you will hear
a tone when it is installed correctly. See picture below for
jack locations.
4. Open the mobile app and select a cooking cycle
designed to work with the temperature probe.
This will vary by model.
5.
Use the mobile app to set the desired Probe
Temperature, Cooking Cycle, Oven Temperature, and
Start the Cycle.
1
2
1
5
2
Temperature Probe Jack (30", 36", and main
cavity on 48" models
Temperature Probe Jack (Left cavity on 48"
models only)
Temperature probe
partially inserted
Temperature probe
fully inserted
NOTE: The temperature probe must be inserted before
opening the mobile app to select a cycle that utilizes the
temperature probe.