Installation Instructions

15
6. Position the broil burner against the roof of the oven cavity
and attach with screw.
To Convert Surface Burners (Nat. gas to Propane)
1. If the burner grates are installed, remove them.
2. Remove the burner caps.
3. Using a Phillips or Torx
®†
screwdriver, remove the burner base.
4. Apply masking tape to the end of a 9/32 "(7.0 mm) nut driver
to help hold the Natural gas orice spud in the nut driver
while changing it. Press nut driver down onto the Natural gas
orice spud and remove by turning it counterclockwise and
lifting out. Set the Natural gas orice spud aside.
Use the following chart for correct propane gas orice spud for
each burner. Refer to the model/serial rating plate behind the
control panel for proper sizing of propane gas orice spuds for
each burner location.
Propane Gas Orice Spud Chart
Burner Rating Color Number
5. Replace the Natural gas orice spud with the correct
propane gas orice spud. See the “Propane Gas Orice
Spud Chart.”
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place Natural gas orice spuds in plastic parts bag for future
use and keep with package containing literature.
10. Replace burner grates.
11. Complete installation. See “Make Gas Connection” and
“Electronic Ignition System” sections.
Checking for proper cooktop burner ame is very important.
The small inner cone should have a very distinct blue ame
¼" to ½" (6.3 mm to 12.7 mm) long. The outer cone is not as
distinct as the inner cone. Propane gas ames have a slightly
yellow tip.
IMPORTANT: You may have to adjust the “Low” setting
for each cooktop burner. See “Adjust Flame Height” in the
“Electronic Ignition System” section.
Natural Gas Conversion
1. Turn manual shutoff valve to the closed position.
2. Unplug range or disconnect power.
A
B
A. Broil burner orifice hood
B. Broil burner
A
B
C
D
A. Burner cap
B. Gas tube opening
C. Burner base screws
D. Burner base
A
A. Natural gas orifice spud
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
A
B
C
A. To range
B. Shutoff valve (closed position)
C. Gas supply line
4,000 BTU
7,000 BTU
9,100 BTU
14,000 BTU
Blue
Black
Green
Red
64L
81L
97L
114L
†
®
TORX is a registered trademark of Acument Intellectual Properties, LLC.