Owner's Manual
Table Of Contents
- RANGE SAFETY
- Range Safety
- RANGE MAINTENANCE AND CARE
- Self-Cleaning Cycle
- General Cleaning
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements (for Dual Fuel models) - U.S.A. Only
- Electrical Requirements (for Dual Fuel models) - Canada Only
- Electrical Requirements (for Gas models)
- Gas Supply Requirements
- INSTALLATION
- Unpack Range
- Install Anti-Tip Bracket
- Make Gas Connection
- Verify Anti-Tip Bracket Is Installed and Engaged
- Level Range
- Electronic Ignition System
- Complete Installation
- Remove Oven Doors
- Adjust Leveling Legs
- GAS CONVERSIONS
- Propane Gas Conversion
- Natural Gas Conversion
- Moving the Range
- SÉCURITÉ DE LA CUISINIÈRE
- Sécurité de la cuisinière
- ENTRETIEN ET RÉPARATION DE LA CUISINIÈRE
- Programme d’autonettoyage (sur certains modèles)
- Nettoyage général
- INSTRUCTIONS D’INSTALLATION
- EXIGENCE
- Outils et pièces
- Exigences d’emplacement
- Spécifications électriques (Pour les modèles à bi-combustible) - Canada seulement
- Spécifications électriques (pour cuisinières à gaz)
- Spécifications de l’alimentation en gaz
- INSTALLATION
- Déballage de la cuisinière
- Installation de la bride antibasculement
- Raccordement au gaz
- Vérifier que la bride antibasculement est bien installée et engagée
- Réglage de l’aplomb de la cuisinière
- Système d’allumage électronique
- Achever l’installation
- Enlever la/les portes du four
- Réglage des pieds de nivellement
- CONVERSIONS POUR CHANGEMENT DE GAZ
- Conversion pour l’alimentation au propane
- Conversion pour l’alimentation au gaz naturel
- Déplacement de la cuisinière
18
2. Unscrew the regulator cap, and then remove the plastic cover.
A. Plastic cover
B. Regulator cap
3. Flip the regulator pin over, and then replace the plastic cover.
A. Natural gas position
B. Propane gas position
C. Plastic cover
4. Screw the regulator cap securely back into place. Do not
overtighten.
To Convert Oven Bake Burners (Natural gas to
Propane)
To Convert Lower Oven Bake Burner:
1. Remove oven racks from inside the oven cavity.
2. Remove oven door. See the Oven Door Removal Guide for
oven door removal instructions.
3. Push the bake burner cover to the right.
A. Bake burner cover
4. Lift up and remove oven bake burner cover.
5. Unscrew wing nut and remove oven baffle.
A. Oven baffle
B. Wing nut
6. Remove the oven bake burner screw and set aside.
7. Gently set the bake burner to the side.
A. Igniter and wires
B. Bake burner screw
8. Unscrew and remove the cover over the orifice.
A. Orifice cover