Control Guide

9
To Remove Roll-Out Rack
1. Push the sliding shelf in completely so that it is in the closed
and engaged position.
2. Using 2 hands, gently pull the sliding shelf and the slide rails
at the same time to the “V” cutout. Angle the rack so that the
front is higher than the back, and then gently pull rack past “V”
cutout and then out of the oven.
To avoid damage to the sliding shelves, do not place more than
25 lbs. (11.4 kg) on the rack.
Do not clean the roll-out rack in the dishwasher. It may remove the
rack’s lubricant and affect its ability to slide.
See the “General Cleaning” section in your Owner’s Manual for
more information.
Baking and Roasting
Preheating
When beginning a Bake, Convect Bake, or Convect Roast cycle,
the oven will begin preheating after Start is pressed. The oven will
take approximately 12 to 15 minutes to reach 350°F (177°C) with
all of the oven racks provided with your oven inside the oven
cavity. Higher temperatures will take longer to preheat. The
preheat cycle rapidly increases the oven temperature. The actual
oven temperature will go above your set temperature to offset the
heat lost when your oven door is opened to insert food. This
ensures that when you place your food in the oven, the oven will
begin at the proper temperature. Insert your food when the
preheat tone sounds. Do not open the door during preheat before
the tone sounds.
Oven Temperature
While in use, the oven elements will cycle on and off as needed to
maintain a consistent temperature, but they may run slightly hot or
cool at any point in time due to this cycling. Opening the oven door
while in use will release the hot air and cool the oven which could
impact the cooking time and performance. It is recommended to
use the oven light to monitor cooking progress.
NOTE: On models with convection, the convection fan may run in
the non-convection Bake mode to improve oven performance.
Temperature Management System
The Temperature Management System electronically regulates
the oven heat levels during preheat and bake to maintain a
precise temperature range for optimal cooking results. The bake
and broil elements or burners cycle on and off in intervals. On
convection range models, the fan will run while preheating and
may be cycled on and off for short intervals during bake to provide
the best results. This feature is automatically activated when the
oven is in use.
Before baking and roasting, position racks according to the
“Positioning Racks and Bakeware” section. When roasting, it is
not necessary to wait for the oven preheat cycle to end before
putting food in unless it is recommended in the recipe.
Steam Bake
The Steam Bake function works in conjunction with the steam
rack to provide additional moisture during baking. The steam rack
contains a water reservoir which heats up and releases steam into
the oven cavity during the Steam Bake cycle. There are 3
preprogrammed food options to choose from: Breads, Desserts,
and Fish as well as a Refresh/Reheat option.
For best performance, place the steam rack in the lowest available
rack position in the cavity and pour 1
1
/
2
cups (350 mL) of water into
the reservoir. Do not fill past the MAX level indicated on the
reservoir.
After the Steam Bake cycle is complete, some water may remain
in the reservoir. This is normal. Wait for the oven to cool and
discard the water.
A. Steam rack
B. Water reservoir
Broiling
Close the oven door while broiling. No preheating is necessary.
Position food on grid in a broiler pan, and then place it in the
center of the oven rack.
NOTE: Odors and smoke are normal the first few times the oven
is used or if the oven is heavily soiled.
Changing the temperature when broiling allows more precise
control when cooking. The lower the broil setting, the slower the
cooking. Thicker cuts and unevenly shaped pieces of meat, fish,
and poultry may cook better at lower broil settings. Refer to the
“Positioning Racks and Bakeware” section for more information.
On lower settings, the broil element will cycle on and off to
maintain the proper temperature.
For best results, use a broiler pan and grid. It is designed to
drain juices and help avoid spatter and smoke.
If you would like to purchase a broiler pan, one may be
ordered. Please refer to the Quick Start Guide for contact
information.
Lower Oven Convection Cooking
In a convection oven, the fan-circulated hot air continually
distributes heat more evenly than the natural movement of air in a
standard thermal oven. This movement of hot air helps maintain a
consistent temperature throughout the oven, cooking foods more
evenly, crisping the surfaces while sealing in moisture and yielding
crustier breads.
During the convection cooking, the bake, broil and convection
(true convection only) elements cycle on and off in intervals to
maintain the oven temperature, while the fan circulates the hot air.
If the oven door is opened during convection cooking, the fan will
turn off immediately. It will come back on when the oven door is
closed.
NOTE: The oven door must be closed for convection broiling.
Position the racks according to the “Positioning Racks and
Bakeware” section before starting convection cooking.