Installation guide

3. Select bracket mounting holes that will allow the bracket to
Installing Brackets Before Placing Cooktop in Cutout extend far enough out from the cooktop for the installation of
2¥2" (6.4 cm) clamping screws.
1. Using 2 or more people, place the cooktop upside down ona
covered surface.
A ae
2. Remove the attachment screws for the selected bracket
locations from the bottom of the cooktop base.
3. Select bracket mounting holes that will allow the bracket to
extend far enough out from the cooktop for the installation of B
2%" (6.4 cm) clamping screws. See “Attach Cooktop to
Countertop” for illustration of clamping screw installation.
A. Cooktop
B. Cooktop base
C. Attachment screw
D. Clamping bracket (extends far enough beyond
cooktop base to allow installation of clamping
screws)
E. 2%" (6.4 cm) clamping screw (to be installed in
A. Edge of cooktop base bottom “Attach Cooktop to Countertop”)
B. Clamping bracket F, Countertop
4. Attach brackets to cooktop base bottom with bracket 4. Attach brackets to cooktop base bottom with bracket
attachment screws using the bracket mounting holes attachment screws using the bracket mounting holes
selected in Step 2. selected in Step 3. Securely tighten screws.
f
5. Rotate brackets so they do not extend beyond edge of
cooktop
base.
Vake
ection
6.
Tighten
screws
just
enough
to
hold
brackets
in
place
when
cooktop is put in cutout.
7. Using 2 or more people, turn the cooktop right side up and AWARNING
place in cutout.
NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning is
needed, lift entire cooktop up from cutout to avoid scratching
the countertop.
he pen,
sos Conn “as seen
i
~"
s
%
s
8. Loosen the screws and rotate the brackets so that they are .
perpendicular to the edge of the cooktop base and extend Explosion Hazard
beyond its edge. Securely tighten screws. Use a new CSA International approved gas supply line.
Installing Brackets After Placing Cooktop in Cutout Install a shut-off valve.
Securely tighten all gas connections.
1. Using 2 or more people, place cooktop right side up into the i
cutout people, P pig P If connected to LP, have a qualified person make sure
NOTE: Make sure that the front edge of the cooktop is gas pressure does not exceed 14" (36 cm) water
parallel to the front edge of the countertop. If repositioning is column.
needed, lift entire cooktop up from cutout to avoid scratching Examples of a qualified person include:
the countertop. licensed heating personnel,
2. Remove the attachment screws for the selected bracket authorized gas company personnel, and
locations from the bottom of the cooktop base. authorized service personnel.
Failure to do so can result in death, explosion, or fire.
To Assemble Pressure Regulator:
1. Using 2 or more people, stand the cooktop on its side or
back.