Use and Care Guide

English

ASSEMBLING THE FOOD PROCESSOR ASSEMBLING THE FOOD PROCESSOR

Attaching the work bowl cover

NOTE: Be sure to install the desired accessory before attaching the work bowl cover.

Place the work bowl cover on the work

bowl with the feed tube just to the left

of the work bowl handle. Grasp the feed

tube and turn the cover to the right until

it locks into place.

Fit the food pusher into the 3-in-1

feed tube. See “Using the 3-in-1 Feed

Tube” for details on working with

different sized foods.

NOTE: Your Food Processor will not operate unless the work bowl and work bowl cover

are properly locked on the base, and the large pusher is inserted to the maximum fill line on

the feed tube (approximately halfway down).

Installing the adjustable slicing disc

Hold the slicing disk by the finger grips

and lower it onto the drive adapter.

You may need to turn the disc/drive

adapter until it drops down into place.

Install the work bowl cover, being sure

it locks into place.

TIP: You may need to turn the disc/adapter until it drops down into place.

W10625435A_v3.indd 9 7/29/13 11:22 AM