Installation guide

Befere youstart°°°
Your safety and the safety of
others are very important.
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
This is the safety alert
symbol.
This symbol alerts you to
potential hazards that can kill or hurt
you and others.
All safety messages will follow the
safety alert symbol and either the
word "DANGER" or "WARNING".
These words mean:
You can be killed or seriously
injured if you don't immediately
follow instructions.
You can be killed or seriously
injured if you don't follow
instructions.
All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
Important: Observe aH governing
codes and ordinances.
WARNING: _f the
information in this manua_
is not followed exactly, a
fire or expRosion may result
causing property damage,
persona_ injury or death.
m Do not store or use
gasoline or other
flammable vapors and
_iquids in the vicinity of
this or any other
appliance.
WHAT TO DO _FYOU
SMELL GAS
o Do not try to _ight any
appliance.
o Do not touch any
eRectrica[ switch.
o Do not use any phone in
your building.
o _mmediatemy cam[your
gas supplier from a
neighbor's phone. Follow
the gas supp_[er's
instructions.
o _f you cannot reach your
gas supplier, call the fire
department.
_nstaHation and service
must be performed by a
quamified installer, service
agency or the gas
supplier.
Note: This cooktop is manufactured for
use with Natural gas. To convert to
LR/Propane gas, see instructions in the
Gas Conversion Kit provided in literature
package.
Proper gas suppJy connection must be
available. See "Gas supply requirements,"
Page 4.
Proper installation is your responsibility.
Have a qualified technician install this
cooktop.
Make sure you have everything
necessary for correct installation. It is the
responsibility of the installer to comply
with the installation clearances specified
on the model/serial rating plate. The
model/serial rating plate can be found on
the underside of the cooktop burner box.
Check location where cooktop will be
installed. The location should be away
from strong draft areas, such as windows,
doors and strong heating vents or fans.
Do not obstruct flow of combustion and
ventilation air.
All openings in the wall or floor where the
cooktop is to be installed must be sealed.
When installing a cooktop under existing
cabinets and the installation does not
meet the minimum cabinet clearances,
install a range hood above the cooktop to
avoid burn hazards.
Electdcat ground is required. See
"Electrical Requirements," Pages 4-5.
It is the customer's responsibility:
To contact a qualified electrical
instaJJer.
To assure that emectrical installation is
adequate and in conformance with
Nationam EJectrical Code, ANSJ/NFPA
70 -- latest edition*, or Canadian
Electrical Code, C22.1 -1982 and C22.2
No. 01982 (or Jatest edition)** and aH
local codes and ordinances.
Copies of the standards listed may be obtained
from:
*National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
** CSA Bntemational
6501 East Pmeasant Valley Rd.
C_eveJand, OH 44131-8575
neededfer
pencil