Installation Instruction

11
7. Insert the orice tube on the front of the burner assembly
into the opening at the front of the grill basin and set burner
assembly into place.
8. Insert front tabs of the ame spreader into slots at the front
of the grill basin, then the rear tabs into the rear slots.
9. Check the surface burner and grill ames. Refer to the
“Electronic Ignition System” section.
10. Place the wave tray on top of the ame spreader.
11. Place the grill grate into position.
Install Griddle
(on griddle models)
The griddle is factory installed.
1. Place drip tray in the well at the front of the griddle. Slide tray
toward the back until it stops.
2. Clean griddle before using. Refer to the Use and Care Guide.
Complete Installation
Install Burner Bases and Burner Caps
Install the burner base, making sure the igniter electrode is
properly aligned with the base. Place burner caps on top
of burner bases. If burner caps are not properly positioned,
surfaceburners will not light.
Ultra Power™ Dual-Flame Burner
Professional Burner
Simmer/Melt Burner
Electronic Ignition System
Initial lighting and gas ame adjustments
Cooktop burners use electronic igniters in place of standing
pilots. When the cooktop control knob is turned to any position,
the system creates a spark to light the burner. This sparking
continues until the ame is lit or the knob is turned to OFF.
Check Operation of Cooktop Burners
Push in and turn each control knob to the LITE position.
The surface burners and grill ames should light within
4seconds. The rst time a burner is lit, it may take longer
than4seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control
knobs to OFF.
If burners do not light properly:
■ Turn cooktop control knob to the OFF position.
■ Check that the cooktop is plugged in and the circuit breaker
has not tripped or the fuse has not blown.
■ Check that the gas shut-off valves are set to the
“open”position.
■ Check that burner caps are properly positioned on
burnerbases.
Repeat start-up. If a burner does not light at this point, contact
your dealer or authorized service company for assistance.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use
and Care Guide or contact the dealer from whom you purchased
your cooktop.
A
A. Front opening
A
B
A. Front tabs and slots
B. Rear tabs and slots
A
B
A. Griddle drip tray
B. Griddle
A
B
A. Incorrect
B. Correct
A
B
A. Incorrect
B. Correct
A
B
A. Incorrect
B. Correct