Installation Instruction

15
Propane Gas Orice Spud/Hood Chart
Burner
Rating
Color Size Burner Style
3,000 BTUs Blue 0.55 mm Small burners
11,000 BTUs Yellow 0.97 mm Medium burners
14,000 BTUs Red/Green
Green
1.05 mm
0.35 mm
Large burner - main
Large burner - simmer
14,500 BTU Black 1.18 mm Grill burner
(onsomemodels)
Burner orice spud Grill orice hood
A
A
A. Size stamp or color A. Size stamp
6. Place Natural gas orice spuds in plastic parts bag for future
use and keep with package containing literature.
NOTE: There may be extra orices in your kit.
7. Replace the burner base.
8. Replace burner cap.
9. Repeat steps 2 through 8 for the remaining burners.
To Convert Grill Burner (on some models)
1. Remove grill grate, wave plate, ame spreader and burner
assembly. See “Install Grill Grease Trays” section for removal
instructions. Set parts aside.
2. Use a 1/2" (13 mm) deep-well socket to remove the Natural
gas orice hood. Replace with correct grill Propane gas
orice hood. See “Propane Gas Orice Spud/Hood Chart.”
3. Turn Propane gas orice hood down tightly onto orice base.
4. Place Natural gas orice hoods in plastic parts bag for future
use and keep with package containing literature.
5. Before replacing the burner assembly, loosen the screw at
the front of the burner and rotate the shutter so that the
opening is 5/16" (8.0 mm) wide.
6. Reinstall the burner assembly, ame spreader, wave plate,
and grill grate. See “Install Grill Grease Trays” section for
installation instructions.
7. Open shutoff valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
REMEMBER: Once you have completed converting the
grill, test the cooktop for leaks by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show,
indicating a leak. Correct any leaks found.
8. Plug in cooktop or reconnect power.
Complete Installation
1. Refer to the “Make Gas Connection” section for properly
connecting the cooktop to the gas supply.
2. Refer to the “Electronic Ignition System” section for proper
burner ignition, operation, and burner ame adjustments.
IMPORTANT: You may have to adjust the LO setting for each
cooktop burner.
Checking for proper cooktop burner ame is very important.
The small inner cone should have a very distinct blue ame
1/4" (6.4 mm) to 1/2" (13 mm) long. The outer cone is not as
distinct as the inner cone. Propane gas ames have a slightly
yellow tip.
3. Refer to the “Complete Installation” section in the
“Installation Instructions” section of these instructions to
complete this procedure.
A
B
C
Choke
A
A. Grill orice hood location
A
B
A. Shutter opening
B. Screw