Installation Instruction

10
Complete Connection
1. Open the manual shut-off valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
2. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear,
aleak is indicated. Correct any leak found.
3. Remove cooktop burner caps, burner bases, and grates
from parts package. Place burner bases on cooktop. Place
burner caps on burner bases. Place grates over burners
andcaps.
4. Plug into a grounded 3 prong outlet.
5. Check the operation of the surface burners. See “Check
Operation of Cooktop Burners” section in the “Complete
Installation” section.
6. If your model has a grill or griddle, see “Install Grill Grease
Trays” or “Install Griddle” section.
Install Grill Grease Trays
(on grill models)
1. Remove ame spreader. Pull forward slightly on the ame
spreader to release the tabs from the rear slots and lift out.
2. Cut and remove tie strap from rear of burner assembly.
3. Lift burner assembly up and out to remove.
4. Slide drip tray into opening on the right front side of the grill
basin. There are guides to assure correct placement of the
drip tray.
5. Insert the large grease tray all the way under the back edge
of the grill basin and hook it into the slots.
6. Insert the small grease tray all the way under the front of the
grill basin and hook it into the slots.
When the two grease trays are installed properly, the small
grease tray will hook over the large grease tray.
A
B
A. Closed valve
B. Open valve
A
B
A. Grill front
B. Rear tabs and slots
A
A. Tie strap
A
A. Drip tray
A
B
A. Large grease tray
B. Slots
A
B
C
D
A. Large grease tray
B. Grease tray connection
C. Small grease tray
D. Slots