Manual

Troubleshooting
Other problems and their causes:
PROBLEM CAUSE
The oven will not
operate
• You have not set the electronic control correctly. Refer to
the section in this manual describing the function you are
operating.
• You have programmed a delayed start time. Wait for the
start time to be reached or cancel and reset the control.
Burner falls to light
• The range is not plugged or wired into a live outlet or circuit
with the proper voltage. (See Installation Instructions.)
• You have blown a household fuse or tripped a circuit
breaker. In case of prolonged power failure, manually light
burners. (See page 14.)
• The burner ports are clogged. Clean with a straight pin.
(See page 16.)
Burner flames are • The burner ports are clogged. Clean with a straight pin.
uneven (See page 16.) If this fails, call for service.
Burner flames lift off • The air/gas mixture is incorrect. Contact a service techni-
ports, are yellow, or are clan to check it.
noisy when turned off
Burner makes popping • The burner is wet from washing. Let dry.
noise when on
Burners spark • It is normal for all four burners to spark briefly when:
- A burner is turned on, but has not yet ignited.
- There is a draft blowing on burners.
- A very large pot on burner causes flame to be unstable.
No action is needed. Burner operation is not affected and
the sparking should end when the ignitedflame is burning
undisturbed.
• Continuous sparking may be caused when:
- A spillover has wet ignition switch contacts. Turnon one
or two burners or disconnect electrical supply to let
switch dry out.
- There is a faulty spark module. Contact a service techni-
cian to replace module.
- The wall outlet wiring is incorrect. Contact a qualified
electrician to correct wiring, if needed.
Cooling fan runs during
Bake or Broil
• It is normal for the fan to automatically run during Bake or
Broil to cool the electronic control.
59