Installation guide

Adjust Flame Height
Adjust the height of top burner flames. The cooktop "low" burner
flame should be a steady blue flame approximately 1_,,(0.64 cm)
high.
A
A. Low flame
B. High flame
If the "low" flame needs to be adjusted:
Standard burner adjustment
The flame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
A
A. Adjustment screw
1. Remove the control knob.
2. Hold the knob stem with a pair of pliers. Use a small flat-
blade screwdriver to turn the screw located in the center of
the control knob stem until the flame is the proper size.
3. Replace the control knob.
4. Test the flame by turning the control from "LO" to "HI,"
checking the flame at each setting.
TripleTier TM Flame adjustment
The flame can be adjusted using the adjustment screws located
under the control knob.
Check Operation of Oven Bake Burner
1. Remove the oven rack. Remove the bake burner cover and
place it on a protected surface.
2. Push the BAKE pad. Default temperature appears in the
temperature display.
3. Press the START pad. Depending on your model,
"PrE" and preheat time will appear in the temperature display
OR
"PREHEATING" and "LO" (or actual temperature) will appear
in the temperature display.
The oven bake burner should light within 8 seconds, under
certain conditions it may take the burner up to 50 to 60 seconds
to light.
Electronic igniters are used to light the bake and broil burners.
A. Bake burner cover
B. Flame spreader
C. Oven bake burner
Adjust Oven Bake Burner Flame (if needed)
On models with a warming drawer, remove access cover
plate (1 screw) located at the back of the warming drawer
compartment.
Check the oven bake burner for proper flame.
This flame should have a 1/2"(1.3 cm) long inner cone of
bluish-green, with an outer mantle of dark blue, and should
be clean and soft in character. No yellow tips, blowing or
lifting of flame should occur.
If the oven bake flame needs to be adjusted, locate the air
shutter near the center rear of the range. Loosen the locking
screw and rotate the air shutter until the proper flame
appears. Tighten locking screw.
A. Power burner adjustment
B. Simmer burner adjustment
1. Remove the control knob.
2. Insert a small flat-blade screwdriver into adjustment locations
shown to turn the screw until the flame is the proper size.
3. Replace the control knob.
4. Test the flame by turning the control from "LO" to "HI,"
checking the flame at each setting.
4=
5.
A. Air shutter
Push CANCEL/OFF pad.
Reinstall oven bake burner access plate.
11