Installation guide

Typical flexible connection
1. Apply pipe-joint compound made for use with LP gas to the
smaller thread ends of the flexible connector adapters (see B
and G in the following illustration).
2. Attach one adapter to the gas pressure regulator and the
other adapter to the gas shutoff valve. Tighten both adapters.
3. Use a '%e" combination wrench and channel lock pliers to
attach the flexible connector to the adapters. Check that
connector is not kinked.
H G F
A. Gas pressure regulator
B. Use pipe-joint compound.
C. Adapter (must have 2" male
pipe thread)
D. Flexible connector
E, Manual gas shutoff valve
F. ¥2" or 44" gas pipe
G. Use pipe-joint compound.
H. Adapter
Complete Connection
1. Locate gas pressure regulator at rear of storage or warming
drawer compartment.
NOTE: On models with a warming drawer, an access cover
must be removed from the gas pressure regulator.
i
= aa
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
2. Check that the gas pressure regulator shutoff valve is in the
“ON” position. The valve is on when the lever is parallel to the
floor.
A. Gas pressure regulator shutoff valve
3. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A. Closed valve
B. Open valve
12
4. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear, a
leak is indicated. Correct any leak found.
5. Remove cooktop burner caps and grates from parts
package. Align notches in burner caps with pins in burner
base. Burner caps should be level when properly positioned.
If burner caps are not properly positioned, surface burners
will not light.
A. Burner base
B. Burner cap
C. Burner grate
6. Place burner grates over burners and caps as shown in the
following illustration. When properly installed the grates
should not overlap the console.
Freestanding Models
A. Opening in grate for wok insert to be
located over left front burner
Slide-In Models
A. Large flange with rounded corner must be
at rear corner of the cooktop.