Manualshelf

Installation guide

ManualsBrandsKitchenAid ManualsRangeOfficial KitchenAid gas freestanding range
11121314151617181920
GAS
CONVERSIONS
Gas
conversions
from
Natural
gas
to
LP
gas
or
from
LP
gas
to
Natural
gas
must
be
done
by
a
qualified
installer.
AWARNING
Explosion
Hazard
Use
a
new
CSA
International
approved
gas
supply
line.
Install
a
shut-off
valve.
Securely
tighten
all
gas
connections.
If
connected
to
LP,
have
a
qualified
person
make
sure
gas
pressure
does
not
exceed
14"
(36
cm)
water
column.
Examples
of
a
qualified
person
include:
licensed
heating
personnel,
authorized
gas
company
personnel,
and
authorized
service
personnel.
Failure
to
do
so
can
result
in
death,
explosion,
or
fire.
S
Tip
Over
Hazard
A
child
or
adult
can
tip
the
range
and
be
killed.
Connect
anti-tip
bracket
to
rear
range
foot.
Reconnect
the
anti-tip
bracket,
if
the
range
is
moved.
Failure
to
follow
these
instructions
can
result
in
death
or
serious
burns
to
children
and
adults.
To
Convert
Gas Pressure
Regulator
1.
Turn
manual
shutoff
valve
to
the
“closed”
position.
2.
Unplug
range
or
disconnect
power.
A.
To
range
B.
Manual
shutoff
valve
“closed”
position
C.
Gas
supply
line
16
3.
Remove
warming
drawer
or
storage
drawer.
See
the
“Remove
Warming
or
Storage
Drawer”
section
for
instructions.
Locate
gas
pressure
regulator
at
rear
of
storage
or
warming
drawer
compartment.
NOTE:
On
models
with
a
warming
drawer,
an
access
cover
must
be
removed
from
the
gas
pressure
regulator.
(r
fl
at
A.
Gas
pressure
regulator
IMPORTANT:
Do
not
remove
the
gas
pressure
regulator.
Gas
pressure
regulator
4.
Remove
plastic
cover
from
gas
pressure
regulator
cap.
5.
Turn
gas
pressure
regulator
cap
(marked
“N”
on
front
of
gas
pressure
regulator)
counterclockwise
with
a
wrench
to
remove.
NOTE:
Do
not
remove
the
spring
beneath
the
cap.
Side
view
before
Side
view
after
A.
Plastic
cover
B.
Gas
pressure
regulator
cap
with
solid
end
facing
out
C.
Gas
pressure
regulator
cap
with
hollow
end
facing
out
D.
Washer
E.
Gas
pressure
regulator
cap
F.
Gas
regulator
shutoff
valve
(shown
in
the
“open”
position)
6.
Turn
the
gas
pressure
regulator
cap
over
and
reinstall
on
regulator
so
that
the
hollow
end
faces
out
and
letters
“LP”
are
visible.
7.
Replace
plastic
cover
over
gas
pressure
regulator
cap.