Instruction for Use

Important: The following procedure shall be carried out by

competent technical personnel only. The hob can be

installed on different types of materials, such as masonry,

metal, bare wood and heat resistant laminate coated

wood (90°C).

Cut an opening into the worktop to the dimensions shown in the

diagram. In order to correctly fit this type of hob, a 2mm deep

recess around the edge of the opening is also needed.

Before positioning the hob, apply the adhesive seal supplied on

the bottom perimeter of the hob itself, where this will be in

contact with the worktop (fig. 2).

Once the seal is in position, place the hob in the recess. Fix the hob

to the worktop using the screws and brackets provided, tightening

them carefully until the hob is perfectly flush. (fig. 3).

Carefully trim the excess seal. In case of installation on wood

(particularly chipboard), any small spaces between the edge of the

recess and the outside edge of the hob should be filled with small

quantities of silicon sealant (see fig. 4). Once the appliance has been

installed, the bottom part of the hob should be completely accessible.

Important:

• tighten the fixing brackets of the hob to the work top by hand,

using minimum force.

• In case of wooden (or similar) worktops, before fitting the

adhesive seal protect the surface of the milled recess with a

primer.

Fix the hob using the fixing brackets provided.

The appliance is supplied with two types of brackets:

- no. 8 standard length brackets (Service code 4812 404 49874) for

installation on kitchen tops with thickness over 40 mm

- no. 8 long brackets (Service code 4812 404 49875) for installation

on kitchen tops with thickness below 40 mm.

The brackets must be fixed using the appropriate screws both at the

front (no. 4) and at the back (no. 4) using the seats at the bottom of

the hob (fig. 3).

Note: the electrical power cable must be long enough to allow the

hob to be lifted out from above.

1160

1161

1148

21,5

R.10

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fixing the Hob to the worktop. Flush fitted model