Instruction for Use

o replace the injectors in special burner it is neces-

sary to:

1. Remove spreader (C), the screws (B) holding the

cover cap (A) and the cap itself.

2. Unscrew the inner injector (D) and the outer

injector (E) with a box spanner 7.

3. Replace the injectors.

4. Put back the cover cap, screws and spreader.

Note: make sure that:

1. After replacement the spreader (C) is inserted

correctly on the burner.

Injectors replacement in the wok burner

Regulating the minimum flow level must be done with the tap at the

lowest position (small flame) .

There is no need to regulate the primary air in the burners.

To ensure the minimum level is properly regulated, remove the control

knob and adjust the screws found on the tap as follows:

1. tighten to reduce the height of the flame 1 (-)

2. slacken to increase the height of the flame (+);

3. With the burners on, rotate the buttons from the maximum to

the minimum position to check the stability of the flame.

Regulating the minimum flow level of the gas taps