Instruction for Use

5
POTS AND PANS
Only use pots and pans made from ferromagnetic material which are suitable for
use with induction hobs� To determine whether a pot is suitable, check for the
symbol (usually stamped on the bottom)� A magnet may be used to check
whether pots are magnetic�
The quality and the structure of the pot base can alter cooking performance�
Some indications for the diameter of the base do not correspond to the actual diameter of the
ferromagnetic surface�
EMPTY POTS OR POTS WITH A THIN BASE
Do not use empty pots or pans when the hob is on�
The hob is equipped with an internal safety system that constantly monitors the temperature, activating
the “automatic off” function where high temperatures are detected� When used with empty pots or
pots with thin bases, the temperature may rise very quickly, and the “automatic off” function may be
triggered with a slight delay, damaging the pot or pan� If this occurs, do not touch anything, and wait
for all components to cool down�
If any error messages appear, call the service centre�
MINIMUM DIAMETER OF POT/PAN BASE FOR THE DIFFERENT COOKING AREAS
centred on 1
point
2 points
covered
3 points
covered
4 horizontal
points
covered
4 vertical
points
covered
10 cm 19 cm
sh kettle/wire
rack
sh kettle/wire
rack
24 cm
NOOK
POWER CONTROL
With the “Power control” function, you can set the maximum power level for the hob, based on your
needs or on the capacity of your mains power supply�
Once the maximum power has been set, the hob automatically adjusts the charge distribution to the
different cooking zones and an acoustic signal will sound when the limit is reached�
This setting can be used at any time and will remain until it is changed�
At the time of purchase, the hob is set to the maximum possible power (nL)� The maximum power level
(nL) is printed on the identication plate on the bottom of the hob.
To set the hob power:
Once the appliance is connected to the mains power, the power level can be set within 60 seconds�
• Press and hold down the “+” control for 3 seconds� The display will read �
• Hold down the control until the last power setting is shown�
• Use the “+” and “−” controls to select the required power�
Available power settings are: 2�5 kW – 4�0 kW – 6�0 kW – 7�4 kW�
• Press to conrm.
The selected power will remain in the memory, even in the case of a power outage�
To vary power levels, disconnect the appliance from the mains power for at least 60 seconds, then
reconnect it and repeat the steps above�
In case of error during the setting sequence, the display will show the symbol and an acoustic signal
First time use
Accessories