Setup and user guide

6
SWITCHING THE HOB ON/OFF
To turn the hob on, press the power button for around 1 second, until the cooking zone display lights up�
To turn the hob off, press the same button again, and all cooking zones will be deactivated�
If no function is selected, the hob will automatically switch off after 10 seconds�
If the hob is being used, switching it off will switch off all cooking zones, and the residual heat indicator,
“H”, will remain lit until all of the cooking zones have cooled�
POSITIONING
1. Locate the desired cooking zone, by referring to the position symbols at the bottom of each slide
touchscreen�
2. Place the pan in the chosen area, making sure that it covers one or more of the reference marks on
the surface of the hob�
3. Do not cover the control panel symbols with the cooking pot�
Please note: In the cooking zones close to the control panel, it is advisable to keep pots and pans inside
the markings (taking both the bottom of the pan and the upper edge into consideration, as this tends to
be larger)�
This prevents excessive overheating of the touchpad� When grilling or frying, please use the rear
cooking zones wherever possible�
To vary power levels, disconnect the appliance from the mains power for at least 60 seconds, then
reconnect it and repeat the steps above�
In case of error during the setting sequence, the display will show the symbol and an acoustic signal
will be sounded� In this case, you will need to repeat the operation�
If the error persists, contact the assistance service�
ACOUSTIC SIGNAL ON / OFF
To switch the acoustic signal on/off:
• Switch on the cook top�
• Hold down the
P
control on the rst slider to the left, for 3 seconds.
Any alarms set will remain active�
3”
P
Max
18
MinMed
O
P
Max
18
MinMed
O
P
Max
18
MinMed
O
P
Max
18
MinMed
O
Daily use