Instruction for Use

16
WARNING
- Never use steam cleaners.
- Before cleaning, make sure that the cooking zones are switched off and the residual heat
indicator ("H") is not displayed.
IMPORTANT: Do not use abrasive sponges or pan scourers as these could damage the surface of the
glass.
• Clean the hob after every use (wait until it has cooled down first) to remove any food residues.
• Sugar and foods with a high sugar content may damage the glass ceramic surface and must be
removed immediately.
• Salt, sugar and sand can scratch the surface of the glass.
• Use a soft cloth, absorbent kitchen towel or a specific hob cleaner (follow the manufacturer’s
instructions).
• Read and follow the instructions given in the "Instructions for use" section.
• Connect the hob to the electricity supply and check that the supply has not been cut off.
• Clean the hob and dry it thoroughly.
• If you are unable to switch off the hob after using it, disconnect it from the power supply.
• If alphanumeric codes appear on the display when the hob is switched on, consult the following
table for instructions.
FAULT CODE DESCRIPTION POSSIBLE CAUSES REMEDY
The hob switches off
and, after 30 seconds, a
signal sounds every 10
seconds.
Continuous pressure on
the control panel area.
Water or utensils on the
control panel.
Clean the control panel.
C81, C82, C83 The control panel has
switched off because of
excessively high
temperatures.
The internal
temperature of the
electronic components
is too high.
Wait for the hob to cool
down before using it
again.
F42 or F43 The connection voltage
is incorrect.
The sensor has
detected a discrepancy
between the appliance
voltage and that of the
mains supply.
Disconnect the hob
from the mains and
check the electrical
connection.
F12, F21, F25, F36, F37,
F40, F47, F56,
F58, F60, F61, F62, F63,
F64
Call our after-sales service and state the error code.
Troubleshooting
Cleaning