Instruction for Use

Installation

TECHNICAL INFORMATION FOR THE INSTALLER

• Use protective gloves for handling, preparing and installing the product�

• This product can be embedded in a worktop 20 ÷ 60 mm thick�

• If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the

work surface� This panel must be positioned at a maximum distance of 150 mm below the upper surface of the

work surface but, in no case less than 20 mm from the bottom of the hob� In the case that you intend to install an

oven beneath the hob, make sure that it is equipped with a cooling system�

DIMENSIONS AND DISTANCES TO BE MAINTAINED

R = Min. 6.5 mm

Max. 8 mm

Min. 70 mm

730 mm

min. 480 mm

max. 492 mm

510 mm

560 mm

min. 38 mm

max. 42 mm

750mm

100mm

50mm

NOTE: Kitchen cabinets adjacent to the appliance and taller than the top of the hob must be at least 200

mm from the edge of the hob. Hoods must be installed according to their relative installation instruction

manuals and at a minimum distance of 650 mm from the hob (see gure). Place the wall cabinets adjacent

to the hood at a minimum height of 420 mm from the hob (see gure). If the hob is installed beneath a wall

cabinet, the latter must be situated at a minimum of 700 mm above the hob.

ASSEMBLY

After having cleaned the perimeter surface, apply the supplied gasket to the

hob as shown in the gure.

Position the hob in the worktop opening made respecting the dimensions indicated

in the Instruction�

NOTE: the power supply cable must be long enough to permit its upward

extraction.

To secure the hob, use the brackets (A) provided with it� Fit the brackets into the relevant bores shown by the arrow

and fasten them by means of their screws in accordance with the thickness of the worktop (see the following gures)�

20 mm 40 mm

30 mm 60 mm

GAS CONNECTION

• Connect elbow (A)* or (B)* supplied with to the hob inlet main pipe and interpose the washer (C)

supplied, in compliance with EN 549�

* Use elbow (A) for United Kingdom and elbow (B) for all other destinations.

• After connection to the gas supply, check for leaks with soapy water� Light up the burners and

turn the knobs from max position to minimum position to check ame stability�

IMPORTANT: Before connection remove a transport plug from the connecting hole of the

cooker gas pipeline.