Owner's Manual
Table Of Contents
- GETTING STARTED_HM_OM_W11634658A
- PRODUCT ASSEMBLY_HM_OM_W11634658A
- PRODUCT USAGE_HM_OM_W11634658A
- CARE AND CLEANING_HM_OM_W11634658A
- Cordless_Warranty and Service_NAR_Common_One Year
- MISE EN PLACE_HM_OM_W11634658A
- ASSEMBLAGE DU PRODUIT_HM_OM_W11634658A
- DÉMONTAGE DU PRODUIT_HM_OM_W11634658A
- ENTRETIEN ET NETTOYAGE_HM_OM_W11634658A
- Sans fil_Garantie et service_NAR_Standard_Un an
- GETTING STARTED_HM_OM_W11634658A
- PRODUCT ASSEMBLY_HM_OM_W11634658A
- PRODUCT USAGE_HM_OM_W11634658A
- CARE AND CLEANING_HM_OM_W11634658A
- Cordless_Warranty and Service_NAR_Common_One Year
EN
5
BATTERY CHARGING
USING THE USB CABLE
1. Attach the USB Cable to the adapter. Connect the other end of the USB Cable to the
Battery.
2. Plug the adapter into a power source.
USING THE DOCKING STATION (OPTIONAL)
1. Attach the USB cord to the adapter.
2. Plug the adapter into a power source.
3. Turn the Battery upside down and slide the Battery onto the dock.
4. Press down and the latch will snap into place.
5. Upon initial plugging in the Battery into the charger, the Battery LEDs will alternate for a
few seconds as it performs a self-diagnostic of the Battery status.
6. After diagnostic is complete, the Battery will begin charging with a single LED flashing.
LEDs will become solid in color as charging progresses. When Battery is fully charged, all
LEDs will become solid and remain ON for 1 hour.
NOTE: If initial alternating light pattern continues for more than 10 seconds, the Battery may
be too warm or too cold to charge. Unplug Battery and allow it to stabilize to a normal room
temperature and try charging again. If Battery is still not charge after this, unplug Battery and
contact customer service.
BATTERY STATUS
LED INDICATION BATTERY LEVEL
○○○○ 75–100%
○○○� 50–75%
○○�� 25–50%
○��� < 25%
⛭���
When Battery has only 10% Battery level, 1 LED
start to flash at rate of 1 second ON/1 second OFF
(0.5 Hz).
Full Charge: The Battery will be fully charged in around 3 hours.
NOTE: LED Legend Indication:
○ = ON
� = OFF
⛭ = FLASH
NOTE: When the Battery is installed or when the appliance is operated, the Battery charge
status LEDs will display for 5 seconds and then turn off. If the Battery charge is 10% or less,
the indication light will continue to flash until the unit is no longer in use or Battery is removed.
NOTE: It is best to store the Cordless Hand Mixer at room temperature.
PRODUCT ASSEMBLY
1. IMPORTANT: Make sure that the Speed Controller is at “O” position before attaching and
removing Stainless Steel Turbo Beater II
™ accessories.
2. There are two Stainless Steel Turbo Beater II™ accessories. One is without a collar and
another with a collar.