User guide

If you are using a dierent kind of gas from the one

indicated on the serial no. plate and the orange

label on the back of the hob, you must replace the

injectors; in the case of the Wok burner, adjust the

primary air (see Injector table on page 11).

The orange label should be removed and kept

together with the manual.

Use pressure regulators suitable for the gas

pressures indicated on page 11.

• In order to replace the injectors, contact the

Customer Care Centre on 00800-3810-4026,

or a qualied electrician.

• Injectors not supplied as standard should be

requested from the Customer Care Centre on

00800-3810-4026.

• Regulate the minimum levels of the taps.

Note: with liquid petroleum gas ( G30/G31) the

bypass screw must be screwed in fully. If you

then experiance diculty in turning the control

knob, contact our After sales Service though

our Customer Care Centre on 00800-3810-4026,

who will arrange for a replacement after

ascertaining that the tap is damaged.

Adaption to a dierent type of gas supply

Replacing the injectors

Note: Refer to the table on page 11 to ensure the correct type

of injector is to be tted.

Traditional burners (T)

1. Remove the cap (A).

2. Remove the spreader (B).

3. Unscrew the injector (C) with a box spanner 7.

4. Replace the injector with the one for the new gas.

5. Put back burners and pan supports.

Note: Before installing the hob, please remember to stick the

gas calibtration label, provided with the replacement

injectors over the gas information on the underside of the

hob.