User guide

Injectors replacement in the wok burner

To replace the injectors in special burner it is necessary to:

1. Remove spreader (C), the screws (B) holding the cover cap (A) and

the cap itself.

2. Unscrew the inner injector (D) with a box spanner 7 and the outer

injectors (E) with a wrench 7.

3. Replace the injectors.

4. Put back the cover cap, screws and spreader.

Note: make sure that after replacement the spreader (C) is inserted

correctly on the burner.

Regulating the minimum ow level of the gas taps

Regulating the minimum ow level must be done with the tap

at the lowest position (small ame)

There is no need to regulate the primary air in the burners.

To ensure the minimum level is properly regulated, remove the

control knob and adjust the screws found on the tap as follows:

1. Tighten to reduce the height of the ame 1 (-)

2. Unscrew to increase the height of the ame (+);

3. With the burners on, rotate the buttons from the maximum

to the minimum position to check the stability of the

ame.

Once you have nished regulating, close up the seals again

using sealing wax.