User guide

16
Disconnect the appliance from the power
supply.
CLEANING THE HOB SURFACE
• All the enamelled and glass parts should be
cleaned with warm water and neutral solution.
• Stainless steel surfaces may be stained by
calcareous water or aggressive detergents if
left in contact for too long. Any food spills
(water, sauce, coee, etc.) should be wiped
away before they dry.
• Clean with warm water and neutral detergent,
and then dry with a soft cloth or chamois.
Remove baked-on dirt with specic cleaners
for stainless steel surfaces.
NOTE: clean stainless steel only with soft
cloth or sponge.
• Do not use abrasive or corrosive products,
chlorine-based cleaners or pan scourers.
• Do not use steam cleaning appliances.
• Do not use ammable products.
• Do not leave acid or alkaline substances, such
as vinegar, mustard, salt, sugar or lemon juice
on the hob.
CLEANING THE HOB PARTS
• Clean glass and enameled parts only with soft
cloth or sponge.
• Grids, burner caps and burners can be removed
to be cleaned.
• Clean them by hand with warm water and
non-abrasive detergent, removing any food
residues and checking that none of the burner
openings is clogged.
• Rinse and dry.
• Ret burners and burner caps correctly in the
respective housings.
• When replacing the grids, make sure that the
panstand area is aligned with the burner.
• Models equipped with electrical ignition plugs
and safety device require thorough cleaning of
the plug end in order to ensure correct
operation. Check these items frequently, and if
necessary, clean them with a damp cloth. Any
baked-on food should be removed with a
toothpick or needle.
NOTE: to avoid damaging the electric
ignition device, do not use it when the
burners are not in their housing.
Maintenance and cleaning
If the hob will not operate correctly, before calling
the After-Sales Service, refer to the
Troubleshooting Guide to determine the problem.
1. The burner fails to ignite or the ame is not
even
Check that:
• the gas or electrical supplies are not shut o
and especially that the gas supply tap is open;
• the gas cylinder (liquid gas) is not empty;
• the burner openings are not clogged;
• the plug end is not dirty;
• all the burner parts have been positioned
correctly;
• there are no droughts near the hob.
2. The burner does not stay lit
Check that:
• when lighting the burner, the knob has been
pressed for enough time to activate the
protection device;
• the burner openings are not clogged near the
thermocouple;
• the end of the safety device is not dirty;
• the minimum gas setting is correct (see
relevant paragraph).
3. The containers are not stable
Check that:
• the bottom of the container is perfectly at;
• the container is centered on the burner;
• the grids have not been exchanged or
positioned incorrectly.
If after the above checks the fault still occurs, get in
touch with the nearest After Sales Service.
Troubleshooting guide