User guide

7
cylinder or gas container is installed,
it must be properly settled (vertical
orientation).
WARNING: This operation must
be perfomed by a qualied
technician.
Use only exible or rigid metal
hose for gas connection.
Connection with a rigid pipe
(copper or steel) Connection to the
gas system must be carried out in
such a way as not to place any strain
of any kind on the appliance. There
is an adjustable L-shaped pipe
tting on the appliance supply
ramp and this is tted with a seal in
order to prevent leaks. The seal
must always be replaced after
rotating the pipe tting (the seal is
provided with the appliance). The
gas supply pipe tting is a threaded
1/2 gas cylindrical male attachment.
Connecting a exible jointless
stainless steel pipe to a threaded
attachment.
The gas supply pipe tting is a
threaded 1/2 gas cylindrical male
attachment. These pipes must be
installed so that they are never
longer than 2000 mm when fully
extended. Once connection has
been made, make sure that the
exible metal pipe does not touch
any moving parts and is not
compressed. Only use pipes and
seals that comply with current
national regulations.
IMPORTANT: If a staineless steel
hose is used, it must be installed so
as not touch any moving part of the
furniture (e.g.drawer). It must pass
thorugh an area where there are no
obstructions and where it is possible
to inspect it across its entire length.
The appliance should be
connected to the main gas supply
or to a gas cylinder in compliance
with the current national
regulations. Before making the
connection, make sure that the
appliance is compatible with the
gas supply you wish to use.
If it is not, follow the instructions
indicated in the paragraph
"Adapting to dierent types of gas".
After connection to the gas
supply, check for leaks with soapy
water. Light up the burners and turn
the knobs from max position 1* to
minimum position 2* to check
ame stability.
Connection to the gas network
or the gas cylinder may be carryout
using a exible rubber or steel hose,
in accordance with current national
legislation.
ADAPTING TO DIFFERENT TYPES
OF GAS
(This operation needs to be carried
out by a qualied technician.)
In order to adapt the appliance
to a type of gas other than the type
for which it was manufactured
(indicated on the rating label),
follow the dedicated steps provided
after installation drawings.
ELECTRICAL WARNINGS
IMPORTANT: Information about
current and voltage consumption is
provided on the rating plate.
It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by a multi-pole switch
installed upstream of the socket in
accordance with the wiring rules
and the appliance must be earthed
in conformity with national
electrical safety standards.
The power cable must be long enough to
connect the appliance, once tted in its housing,
to the main power supply. Do not pull the power
supply cable.