Installation guide

DB pms 8
Make Ele Salt B
AWARNING
°
Dogk gow. good
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This cooktop is manufactured with a frame-connected, green (or
bare) ground wire.
1. Disconnect power.
2. Remove junction box cover if it is present.
3. Connect the flexible cable conduit from the cooktop to the
junction box using a UL listed or CSA approved conduit
connector.
A. UL listed or CSA approved conduit connector
4. Tighten screws on conduit connector if present.
5. See “Electrical Connection Options Chart” to complete
installation for your type of electrical connection.
Electrical Connection Options Chart
If Your Home Has: Go to Section:
_
1 7 (1.3 em)
4-Wire Cable from Power Supply
3-wire 3-Wire Cable from Power Supply
sal
f
ie
4-Wire Cable from Power Supply to 3-Wire Cable from
Cooktop
IMPORTANT: Use the 4-wire cable from power supply where
local codes do not permit connecting the frame-ground
co
A.
B.
C.
D.
E.
1.
2.
nductor to the neutral (white) junction box wire.
ee
F, Junction box
G. White wire from power supply
H. UL listed wire connector
|. Black wires
J. UL listed or CSA approved conduit
connector with wire bushing
4-wire cable from power
supply
Red wire from power supply
White wire from cooktop cable
Green (or bare) ground wires
from cooktop cable
3-wire cable from cooktop
Connect the red wire (B) (in the junction box) to the white wire
(C) from the cooktop cable using a UL listed wire connector.
Connect the green (or bare) ground wire (D) from the cooktop
cable to the green (or bare) ground wire (in the junction box)
using a UL listed wire connector.
Put a UL listed wire connector on the end of the white
wire (G).
NOTE: Do not connect the green (or bare) ground wire to the
neutral (white) wire in the junction box.
Connect the 2 black wires (I) together using a UL listed wire
connector.
Install junction box cover.