Installation guide

3-Wire Cable from Power Supply to 3-Wire Cable from
Cooktop
IMPORTANT: Use the 3-wire cable from power supply where
local codes permit connecting the frame-ground conductor to
the neutral (white) junction box wire.
A. 3-wire cable from power supply F. Junction box
B. Red wire from power supply G. White wire from power supply
C. White wire from cooktop cable _H. UL listed wire connector
D. Green (or bare) ground wire |. Black wires
from cooktop cable J. UL listed or CSA approved conduit
E. 3-wire cable from cooktop connector with wire bushing
1. Connect the red wire (B) to the white wire (C) from the
cooktop cable using a UL listed wire connector.
2. Connect the green (or bare) cooktop cable wire (D) to the
white (neutral) wire (G) in the junction box using a UL listed
wire connector.
3. Connect the 2 black wires (I) together using a UL listed wire
connector.
4. Install junction box cover.
e
5.
6.
Complete installation
Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
Check that you have all your tools.
Dispose of/recycle all packaging materials.
Use a mild solution of liquid household cleaner and warm
water to clean cooktop before use. Dry thoroughly with a soft
cloth. For more information, see the “Cooktop Care” section
of the Use and Care Guide.
Read “Cooktop Use” in the cooktop Use and Care Guide.
Plug power cord into appropriate outlet. Turn power on.
NOTE: If the cooktop does not work after turning on the power,
check that a circuit breaker has not tripped or a household fuse
has not blown. See “Troubleshooting” section in the Use and
Care Guide for further information.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use
and Care Guide or contact the dealer from whom you purchased
your cooktop.