501974402003_UK 8-10-2007 13:47 Pagina 1 KSCX 3610 Instructions for use
501974402003_UK 8-10-2007 13:47 Pagina 2
501974402003_UK 8-10-2007 13:47 Pagina 3 1 Product description 4 2 Important notes 8 Important information for the correct disposal of the product in accordance with EC directive 2002/96/EC 8 Building-in 9 3 Before first use 11 4 Using for the first time 12 5 Preparing coffee (using coffee beans) 13 6 Changing the quantity of coffee in the cup 15 7 Regulating the coffee mill 15 8 Preparing espresso coffee using ground coffee (instead of beans) 16 9 Hot water delivery 17 10 Preparin
501974402003_UK 8-10-2007 13:47 Pagina 4 1 Product description B Q C I L D V N G E O H F P A. B. C. D. E. F. G. H. I. J. K. L. M. N. O. P. Q. R. S. T. U. V. W.
01974402003_UK 8-10-2007 13:47 Pagina 5 1 Product description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 5
501974402003_UK 8-10-2007 13:47 Pagina 6 1 Product description 17 18 19 20 21 22 23 24 25 26 27 6
501974402003_UK 8-10-2007 13:47 Pagina 7 1 Product description Control Panel 1. Display 2. Appliance ON/OFF knob 3. Coffee taste selection button 4. One or two cups short coffee button 5. One or two cups standard coffee button 6. One or two cups long coffee button 7. Button to select ground coffee or, if the MENU light is on, to display the next parameter on the menu 8. Button to select hot water or OK to confirm 9.
501974402003_UK 8-10-2007 13:47 Pagina 8 2 Important notes READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE CONSULTATION! • This appliance is designed to "make espresso coffee" and "heat drinks". Use with care to avoid scalds from the water and steam jets or through incorrect use. • This appliance is intended for domestic use only. Any other use is considered improper and thus dangerous. • Do not hang to the appliance when it is extracted.
501974402003_UK 8-10-2007 13:47 Pagina 9 Building-in Please check the minimum measures (mm) necessary to the proper installation of the appliance. The coffee maker must be installed in a column unit, which must in turn be securely fixed to the wall with standard brackets. Fasten metal strip using the two screws. . Min ventilation passageway 80 450 455 20 550 . Min 560 50 850 368 80 Min.
501974402003_UK 8-10-2007 13:47 Pagina 10 Building-in 1 2 16 Lean the bars to the surface of the furniture. Fix the bars with the screws provided; then completely extract the two bars. In case of installation above a "warmer drawer", use the top of the latter as a reference for the coffee maker runners. In this case, there will be no support surface. Put the appliance on its housing and fasten it with the screws. 3 4 1 10 mm x.
501974402003_UK 8-10-2007 13:47 Pagina 11 3 Before first use • After removing the packaging, make sure the product is complete and undamaged. If in doubt, do not use the appliance and contact a qualified professional. • Installation must be carried out by a qualified techncian and in compliance with current regulations. • Packing elements (plastic bags, polystyrene etc) must not be left within reach of children as they may represent a hazard.
501974402003_UK 8-10-2007 13:47 Pagina 12 4 Using for the first time The first time you turn on the appliance and every time that it is plugged in, when you turn the main ON/OFF knob clockwise (A), the appliance makes a SELF-DIAGNOSIS operation and then turns itself off. To turn it on again, rotate the ON/OFF knob (2) clockwise on the control panel. 1. The first time you use the appliance, select the language.
501974402003_UK 8-10-2007 13:47 Pagina 13 5 Preparing coffee (using coffee beans) 1. The appliance is preset to make coffee with a standard strength. ‘You can also choose coffee with different strengths. To choose the required strength, press the button (fig.5): and the selected coffee strength will be displayed. 2. Place 1 cup under the spouts to make 1 coffee (fig. 6) or 2 cups for 2 coffees (fig. 7). For a creamier coffee, lower the spouts to bring them as close to the cups as possible (fig. 8). 3.
501974402003_UK 8-10-2007 13:47 Pagina 14 5 Preparing coffee (using coffee beans) NOTE 6: when the appliance displays: FILL TANK the water tank must be refilled or the appliance will not make coffee. (It is normal for there to be a little water left in the tank when the message is displayed). NOTE 7: the appliance counts the number of coffees made.
501974402003_UK 8-10-2007 13:47 Pagina 15 6 Changing the quantity of coffee in the cup The appliance is factory preset to automatically deliver the following quantities of coffee: - short (when the button is pressed); - standard (when the button is pressed); - long (when the button is pressed); To change these quantities, proceed as follows: - press the button corresponding to the quantity you want to change ( , or ) for at least 8 seconds until the message "PROGRAM QUANTITY" is displayed; - when the co
501974402003_UK 8-10-2007 13:47 Pagina 16 8 Preparing espresso coffee using ground coffee (instead of beans) • Press the (fig. 14) button to select the ground coffee function. This disables the coffee mill function. The appliance displays READY PRE-GROUND • Extract the appliance by pulling it using the special handles (fig. 3). • Lift the central lid, place one level measure of ground coffee in the funnel (see fig. 15).
501974402003_UK 8-10-2007 13:48 Pagina 17 9 Hot water delivery • Always make sure the appliance is ready. • Turn the cappuccino maker towards the outside of the appliance and place a container under it (fig. 2). • Press the (fig. 17). The appliance displays: HOT WATER PRESS OK • Press the / button again (fig. 17) for hot water. • Hot water runs off from the cappuccino maker and starts to fill the container underneath. You should not run off hot water for more than 2 minutes at a time.
501974402003_UK 8-10-2007 13:48 Pagina 18 10 Preparing cappuccinos (using steam) • Press the steam button. • Wait a couple of minutes for the cappuccino maker to cool down then with one hand hold the cappuccino spout handle firm and with the other unscrew the cappuccino maker itself by rotating clockwise and extracting downwards (fig. 20). • Remove the nozzle from the steam spout by pulling it downwards (fig. 21). • Carefully wash the cappuccino maker and steam nozzle in warm water.
501974402003_UK 8-10-2007 13:48 Pagina 19 11 Cleaning and maintenance • Wash the infuser under running water, without using detergents. Never wash the infuser in the dishwasher; • clean the inside of the appliance thoroughly. To remove coffee encrustations from the inside of the appliance, scrape with a plastic or wooden fork (fig. 25) then vacuum up the residues with a vacuum cleaner (fig.
501974402003_UK 8-10-2007 13:48 Pagina 20 12 Changing and setting the menu parameters The following menu parameters and functions can be changed by the user: • Clock • Auto-start time • Descaling process • Coffee temperature • Length of time the appliance remains on • Water hardness Factory default values 12.
501974402003_UK 8-10-2007 13:48 Pagina 21 12 Changing and setting the menu parameters • Empty the tank and pour in the contents of one bottle (125 ml) of DURGOL descaler plus one litre of water. For subsequent descaling operations, descaling solution can be purchased from authorised technical service centres. NB: Make sure splashes of descaler do not fall onto surfaces sensitive to acid such as marble, limestone and glaze. • Place a container with a minimum capacity of 1.
501974402003_UK 8-10-2007 13:48 Pagina 22 12 Changing and setting the menu parameters 12.6 Setting water hardness The appliance is preset to display the descale message after a set period of time, based on a set water hardness. You can make descaling less frequent by programming the appliance based on the actual lime content in the water used.
501974402003_UK 8-10-2007 13:48 Pagina 23 14 Meaning of messages and what to do MESSAGE MEANING • The water tank is empty or is positioned incorrectly. FILL TANK GROUND TOO FINE ADJUST MILL AND PRESS THE OK BUTTON • The tank is dirty or encrusted with lime scale. • The appliance cannot make • Press the OK button (fig. 17). coffee. • The coffee runs off too slowly. • Turn the grinding regulator (fig. 10) one click clockwise (see chapter 7). • The grounds container is full.
501974402003_UK 8-10-2007 13:48 Pagina 24 15 Problems that can be resolved before calling the Customer Care Centre If the appliance is not working properly, the causes of the malfunction can be identified and resolved by referring to chapter 14. If, on the other hand, no message is displayed, run the following checks before calling the customer care centre. PROBLEM The coffee is not hot CAUSE SOLUTION • The cups have not been preheated.
501974402003_UK 8-10-2007 13:48 Pagina 25 15 Problems that can be resolved before calling the Customer Care Centre PROBLEM CAUSE SOLUTION Ground coffee is being • Too much ground coffee has used (not beans) and the been added. appliance does not pour the coffee. • The button has not been pressed and the appliance has used both the ground coffee added and the coffee ground by the mill. • Ground coffee has been added when the appliance is off.
501974402003_UK 8-10-2007 13:48 Pagina 26 After-Sales Service Before contacting the Customer Care Centre: Switch the appliance on again to see if the problem has been eliminated. If it has not, switch off the appliance and repeat the operation after one hour.
501974402003_UK 8-10-2007 13:48 Pagina 27
501974402003_UK 8-10-2007 Printed in Italy 10/07 5019 744 02003 13:48 Pagina 28 n GB