Installation

INSTALLATION REQUIREMENTS

Tools and Parts

Tools Needed

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools

listed here.

Parts Supplied

All of the following parts are provided, but not all parts will be

used. The cutout opening size will determine which parts you will

use. See chart below parts list to see which parts are used for

each installation.

Location Requirements

The microwave oven may be located in a cabinet, and/or above a

built-in oven, or below the counter and/or below a non-vented

cooktop. Check the opening where the microwave oven will be

installed. The location must provide:

■ Wood cabinetry.

■ Cutout opening that is plumb and square. See “Minimum

Cutout Dimensions” in “Minimum Dimensions” section.

■ Cutout floor that is solid, level and flush with bottom of

cabinet cutout.

■ Support for weight of at least 150 lbs (68 kg), which includes

microwave oven and items placed inside.

■ Grounded electrical outlet. See “Electrical Requirements”

section.

■ Minimum installation clearances for installation location. See

“Minimum Dimensions” section.

■ Complete enclosure around the recessed portion of the

microwave oven.

■ Measuring tape

■ Pencil

■ T10 TORX

®†

screwdriver

■ Drill

■ 5/64" (2 mm) drill bit

A. Side brackets (2)

B. Extension plates (2)

C. 3/8" T10 screws (4)

D. 1" T10 screws (6)

E. Narrow side trim panels (2)

F. Wide side trim panels (2)

INSTALLATION PARTS USED

24" (61.0 cm) installation D

27" (68.6 cm) installation A, D, E

30" (76.2 cm) installation A, B, C, D, F

†®TORX is a registered trademark of Acument Intellectual Properties, LLC.