BUILT-IN MICROWAVE OVEN INSTALLATION INSTRUCTIONS 24" (61.0 cm}, 27" (68.6 cm), 30" (76.2 cm) This product is suitable for use above electric or gas built-in ovens, and below non-vented electric or gas cook tops. This product is not suitable for use below downdraft cook tops. These Installation Instructions cover different models. The appearance of your particular model may differ slightly from the illustrations in these Installation Instructions.
INSTALLATION REQUIREMENTS Tools and Parts Tools Needed Gather the required tools and parts before starting installation Read and follow the instructions provided with any tools listed here: MW Measuring tape m Drill W Pencil BW 5/84" (2 mm) drill bit W T10 TORX® screwdriver Parts Supplied All of the following parts are provided, but not all parts will be used. The cutout opening size will determine which parts you will use. See chart below parts list to see which parts are used for each installation. A.
Minimum Dimensions Minimum Installation Clearances For proper installation, the following minimum clearances must exist above and below the cutout opening. Above Cabinet/Storage Drawer Installation Above Oven/Warming Drawer Installation Adu ton 38mm) 1] 76 mm) Below Counter Installation Below Built-in Cook top Installation } Sea note below. wd (a8 man) TTT iii (38 T1513) = A Upper cabinet Built-in cook top (non-vented) B. Lower cabinet of storage drawer E. Storage drawer ©.
Minimum Cutout Dimensions Cutout Top View NOTE: Depth dimension may be 21%" (55.2 om) with non-flush receptacle only if the receptacle is located in upper right or upper left corner. See “Cutout Top View". 2137 (55.2 om) 26/4" 66,7 cm)” 26142 lt 22 fe" (66.5 omf ' (66.7 (65,4 OI) i t 44.8 mmm) FE — 21944 eT B52 cm) = | With flush receptacle, or with non-flush receptacle located in upper right or upper left comer of cutout. “With non-flush receptacle. A Microwave ven B. Non-flush receptacle C.
Electrical Requirements KY Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, tire, or electrical shock. Observe all governing codes and ordinances. Required: A120 volt, 60 Hz, AC only. 15or 20-amp electrical supply with a fuse or circuit breaker. Recommencement A time-delay fuse or time-delay circuit breaker.
INSTALLATION INSTRUCTIONS Install the Microwave Oven {24" (81.0 cm] Installation Only) WARNING Excessive Weight Hazard Use two or more people to move and install i microwave oven. $ Failure to do so can result in back or other injury. Electrical Shock Hazard NOTE: For this microwave oven, the door handle may be used Plug into a grounded 3 prong outlet. for lifting. Do not use any other portion of the control panel, side brackets, front frame, or trim for lifting. Do not remove ground prong. 1.
Install the Microwave Oven [277 (68.6 cm] or 30" (76.2 cm) Installation Only} WARNING Excessive Weight Hazard Use two or more people to move and install microwave oven. Failure to do so can result in back or other injury. 1. Empty microwave oven of any loose contents. 2. For 30" installation, attach the extension plate to each of the side brackets using two 3/8” T10 screws, as shown. On some models, the extension plates and side brackets may come per-assembled.
12. Position the tabular portion of the side trim panel behind Com plate Installation the door facing frame, and then firmly push the outside edge of the trim behind the side bracket, as shown. 1. Install the turntable in the microwave oven. 2. Check the operation of microwave oven by placing 1 cup {250 ml} of water on the turntable and programming cook Exploded View of Panel Placement time of 1 minute at 100% power.