Installation Instructions

3. Plug in microwave oven.

4. Slide the microwave oven back and into place. The mounting

holes of the rail anges and bottom duct ange will align

against the bottom front facing of the cutout/cabinet opening.

5. Secure the microwave oven to the cutout/cabinet by installing

four short screws into the mounting holes.

Install Trim Kit Frame

1. Position trim kit frame over the opening so that the lower tabs

rest on the cutout oor, as shown.

2. Holding the trim kit frame in place, use 7/64" (0.28 cm) drill to

drill four pilot holes into the front facing of the cutout/cabinet

through the mounting hole guides in the upper and lower

corners of the trim kit frame.

NOTES:

■ The holes will be drilled downward from the top, and

upward from the bottom at an angle of about 45°.

■ To avoid damage to the trim kit frame, do not overtighten

screws.

A. Mounting hole guide

B. 93# screw (4 - painted)

C. TK Frame

D. Cabinet