Installation guide

INSTALLATIONINSTRUCTIONS
t'O0_S 3_J
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
• Measuring tape • Drill
• Pencil • 7/64" drill bit
• Phillips screwdriver
Parts Supplied (not shown to scale)
Rails (2)
Bottom duct Trimkit frame
Short screws (14)
(11 + 3 extra)
Long wood screws (6 - painted)
(4 + 2 extra)
Loc<:s' F!!equ :emen, ts
The microwave oven may be installed over a built-in oven. If
installing over a built-in oven, make sure there is a minimum of 3"
(7.6 cm) between the top of the lower oven cutout and the
microwave oven cutout floor.
The microwave oven may also be installed in a cabinet by itself
(without a built-in oven below). For best usability, we recommend
a minimum distance of 36" (91.4 cm) from the floor to the cutout
floor.
Make sure the surrounding cabinetry has clearance to open and
close freely. Allow a clearance of at least 1%d' (4.0 cm) below the
cutout floor (3" [7.6 cm] for installation above a built-in oven), and
a clearance of at least 2" (5.1 cm) above the cutout opening.
2"
(5.1cm)
19/16 't
O
IL
(
36"
(91.4 c
2 ,t
crn)
3 ,I
A. Upper cabinet D. Lower cabinets
B. Microwave oven cutout E. Floor
C. Lower oven cutout
17" (43 2 c!) (
mln.
17%" (43.5 cm)
max.
l_/_e,,
(2.7 cm)
/
11/16"
(2.7 cm)
B
A. Trim kit frame overhang
B. Cutout for lower oven
NOTES:
Height dimension is critical: 17" (43.2 cm)minimum, 17V8"
(43.5 cm) maximum.
Width and depth measurements have _+1/16" (2 mm)
tolerance.
3" (7.6 cm) minimum dimension is from lower oven cutout
ceiling to microwave oven cutout floor.
Trim kit frame extends 1Vld' (2.7 cm) above and below the
cutout opening.
I 11
T
187/8"
(47.9 crn)
L
*27" (68.6 cm) trim kit
**30" (76.2 cm) trim kit
267/8'' (68.2 cm)* I
293/4" (75.6 cm)** I
1" (2.5 cm)
2