Installation Instruction

Roof Venting Installation Only

6. If venting through the roof, mark and trace the corner

punches on the mounting plate. Set mounting plate aside,

cut the venting area out from the bottom of the upper

cabinet using a keyhole saw.

Mark Rear Wall

The microwave oven must be installed on a minimum of 1 wall

stud, preferably 2, using a minimum of 1 lag screw, preferably 2.

1. Fold 2 mounting tabs forward into the tab cutout. Note that

the tabs will NOT be ush after folding.

2. Mark centerline on the back wall. Place mounting template

against the back wall, nd and clearly mark the vertical

centerline of the opening.

3. Align the center markers on the mounting plate to the

centerline of the wall. Make sure it is leveled and top of the

mounting plate is butted up against the bottom edge of the

upper cabinet.

NOTE: If the front edge of the upper cabinet is lower than the

back edge, lower the mounting plate so that its top is leveled

with the front edge of the cabinet.

Wall Venting Installation Only

4. If venting through the wall, place mounting plate on the wall

and mark the cut-out area. Set mounting plate aside, then

using a keyhole saw, cut out hole in the wall at back venting

area.

4 Corners

REAR WALLREAR WALL

Fold Forward

A. Centerline

A. Rear wall

B. Mounting Template

C. Top of mounting template must

align with front edge of cabinet

D. Front edge of upper cabinet

Cut-out area for

BACK WALL Venting