Owner's Manual
Table Of Contents
- BUILT-IN MICROWAVE/OVEN COMBO SAFETY
- Built-In Microwave/Oven Combination Safety
- MICROWAVE OVEN MAINTENANCE AND CARE
- General Cleaning
- Self-Cleaning Cycle
- Steam Clean (on some models)
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- INSTALLATIONS
- Prepare Built-In Oven
- Remove Oven Door(s)
- Make Electrical Connection
- Install Oven
- Install Deflector Kit
- Replace Oven Door(s)
- Complete Installation
- SÉCURITÉ DE L’ENSEMBLE FOUR ÉLECTRIQUE/FOUR À MICRO-ONDES ENCASTRÉ
- Sécurité de l’ensemble four électrique/four à micro-ondes encastré
- ENTRETIEN ET RÉPARATION DU FOUR À MICRO-ONDES
- Nettoyage général
- Programme d’autonettoyage
- Steam Clean (nettoyage à la vapeur) (sur certains modèles)
- INSTRUCTIONS D’INSTALLATION
- SPÉCIFICATIONS
- Outils et pièces
- Exigences d’emplacement
- Spécifications électriques
- INSTALLATION
- Préparer le four encastré
- Enlever la/les porte(s) du four
- Raccordement électrique
- Installation du four
- Installation de l’ensemble de déflecteurs
- Réinstallation de la/des porte(s) du four
- Achever l’installation
- SEGURIDAD DE LA COMBINACIÓN DE HORNO MICROONDAS/HORNO INTEGRADO
- Seguridad de la combinación de horno microondas/horno integrado
- MICROWAVE OVEN MAINTENANCE AND CARE
- Limpieza general
- Ciclo de autolimpieza
- Steam Clean (Limpieza con vapor) (en algunos modelos)
- INSTRUCCIONES DE INSTALACIÓN
- REQUISITOS
- Herramientas y piezas
- Requisitos de ubicación
- Requisitos eléctricos
- INSTALACIONES
- Preparación del horno empotrado
- Retire las puertas del horno
- Hacer la conexión eléctrica
- Para instalar el horno
- Instale el kit de deflector
- Vuelva a colocar las puertas del horno
- Finalización de la instalación
13
3-Wire Cable from Home Power Supply – U.S.
Only
IMPORTANT: Use the 3-wire cable from home power supply
where local codes permit a 3-wire connection.
B
C
D
E
F
H
G
A
I
A. Cable from home power supply
B. Junction box
C. Black wires
D. White wires
E. Green (or bare) ground wire
(from oven)
F. 4-wire flexible conduit from
oven
G. Red wires
H. UL listed wire connectors
I. UL listed or CSA approved
conduit connector
1. Connect the 2 black wires (C) together using a UL listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the oven cable) using a UL listed wire connector.
3. Connect the 2 red wires (G) together using a UL listed wire
connector.
4. Install junction box cover.
Install Oven
1. Using two or more people, lift oven partially into cabinet
cutout. Use the oven opening as an area to grip.
NOTE: Push against seal area of oven front frame when
pushing oven into cabinet. Do not push against outside edges.
2. Push against the seal area of the front frame to push the oven
into the cabinet until the back surface of the front frame
touches the front wall of the cabinet.
3. Push oven completely into cabinet and center oven into
cabinet cutout.
4. Securely fasten the oven to the cabinet using the
#8-14 x 3/4" screws provided.
Insert the screws through hole in black trim aligning with hole
in oven frame. Do not overtighten screws.
A.
Oven frame
B. Side trim hole
C. Side trim piece
5. The bottom vent trim and bottom vent shield are shipped in
the foam packing at the top of the oven.
� Align bottom vent shield tab (B) with oven frame (A) as
shown.
� Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the bottom vent shield tab (B), fasten the vent shield
securely to the oven frame (A).
A.
Oven frame
B. Bottom vent
shield tab
C. #8-18 x 3/8" (9.5 mm)
screws
A
B
C
C
B
A