Owners Manual
Table Of Contents
- BUILT-IN MICROWAVE/OVEN COMBO SAFETY
- Built-In Microwave/Oven Combination Safety
- MICROWAVE OVEN MAINTENANCE AND CARE
- General Cleaning
- Self-Cleaning Cycle
- Steam Clean (On Some Models)
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- INSTALLATIONS
- Prepare Built-In Oven
- Remove Oven Door(s)
- Replace Oven Door(s)
- Make Electrical Connection
- Install Oven
- Complete Installation
- SECURITE DE L'ENSEMBLE FOUR ELECTRIQUE/FOUR A MICRO-ONDES ENCASTRE
- Securite de l'ensemble four electrique/four a micro-ondes encastre
- ENTRETIEN ET REPARATION DU FOUR A MICRO-ONDES
- Nettoyage general
- Programme d'autonettoyage
- Steam Clean (nettoyage a la vapeur) (sur certains modeles)
- INSTRUCTIONS D'INSTALLATION
- SPECIFICATIONS
- Outils et pieces
- Exigences d'emplacement
- Specifications electriques
- INSTALLATION
- Preparer le four encastre
- Enlever la/les porte(s) du four
- Reinstallation de la/des porte(s) du four
- Raccordement electrique
- Installation du four
- Achever l'installation
13
3-Wire Cable from Home Power Supply – U.S.
Only
IMPORTANT: Use the 3-wire cable from home power supply
where local codes permit a 3-wire connection.
A. Cable from home power supply
B. Junction box
C. Black wires
D. White wires
E. Green (or bare) ground wire
(from oven)
F. 4-wire flexible conduit from
oven
G. Red wires
H. UL listed wire connectors
I. UL listed or CSA approved
conduit connector
1. Connect the 2 black wires (C) together using a UL listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the oven cable) using a UL listed wire connector.
3. Connect the 2 red wires (G) together using a UL listed wire
connector.
4. Install junction box cover.
Install Oven
1. Using two or more people, lift oven partially into cabinet
cutout. Use the oven opening as an area to grip.
NOTE: Push against seal area of oven front frame when
pushing oven into cabinet. Do not push against outside edges.
2. Push against the seal area of the front frame to push the oven
into the cabinet until the back surface of the front frame
touches the front wall of the cabinet.
3. Push oven completely into cabinet and center oven into
cabinet cutout.
4. Securely fasten the oven to the cabinet using the
#8-14 x 3/4" screws provided.
Insert the screws through hole in black trim aligning with hole
in oven frame. Do not overtighten screws.
A. Oven frame
B. Side trim hole
C. Side trim piece
A
B
C