Installation guide

7
1. Connect the 2 black wires (C) together using a UL listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the oven cable) using a UL listed wire connector.
3. Connect the 2 red wires (G) together using a UL listed wire
connector.
4. Install junction box cover.
Install Oven
1. Using 2 or more people, lift the oven partially into the cabinet
cutout. Use the oven opening as an area to grip.
NOTE: Push against seal area of the oven front frame when
pushing the oven into the cabinet. Do not push against the
outside edges.
2. Push against the seal area of the front frame to push
theoven into the cabinet until the back surface of the
frontframe touches the front wall of the cabinet.
3. Push oven completely into the cabinet and center the oven
into the cabinet cutout.
4. Remove the tape from black front trims.
■ Securely fasten the oven to the cabinet using the #8-14 x
3/4" (1.9 cm) screws provided.
■ Insert the screws through hole in black trim aligning with
hole in oven frame. Do not overtighten screws.
5. The bottom vent is shipped in the foam packing at the top of
the oven. Install the bottom vent (C) as follows:
■ Align vent tab (B) with oven frame (A) as shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (D) on each side
of the venttab (B), fasten the vent securely to the oven.
6. Replace oven racks.
7. Replace the oven door. See the “Replace Oven Door(s)”
section.
8. Check that door is free to open and close. If it is not, repeat
the removal and installation procedures. See “Prepare Built-
In Microwave/Oven Combination” section.
9. Reconnect power.
10. The display panel will light briey, and “PF” should appear in
the display.
11. If the display panel does not light, please reference the
“Warranty” section of the Use and Care Guide.
Install Warming Drawer Deector
Kit (Only for Ovens Installed Above
Warming Drawers)
On combo microwave/oven models installed above a warming
drawer, a warming drawer deector kit must be installed. See the
“Tools and Parts” section for ordering information.
Parts Supplied
A. Oven frame
B. Oven frame hole
C. Black trim piece
A
B
C
A
C
D
B
A. Oven frame
B. Vent tab
C. Oven vent
D. #8-18 x
3
/
8
"
(9.5 mm) screws
B
A
A. Phillips head screws (4)
only 2 screws for 27" (68.6 cm) size
B. Warming drawer deector (1)