Installation guide

9
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Lower Oven
1. Turn on power.
2. At rst use, set up the clock and any other preferences,
if available. For more information, read the Use and Care
Guide.
3. Start a broil cycle. See the User Instructions for instructions.
NOTE: Odors and smoke are normal when the oven is used
the rst few times.
4. Wait 5 minutes, then check for heat.
If Oven Does Not Operate, Check the Following:
■ Household fuse is intact and tight; or circuit breaker has
not tripped.
■ Electrical supply is connected.
■ See the “Troubleshooting” section in the User
Instructions.
5. Place the SatinGlide™ Roll-Out Extension Rack for Smart
Oven+ Attachments in the lowest rack position in the unit to
make sure the correct accessory rack is on the bottom.
6. Press CANCEL OVEN.
Check Operation of Microwave Oven
1. Fill a microwave-safe container with 1 cup (250 mL) of water
and place container inside microwave oven. Close door
rmly.
2. Start a microwave cook cycle for 2 minutes. The interior
microwave oven light should be on, and the remaining
cooking time should be displayed.
When display reads “1:00” minute, open microwave oven
door. The microwave should stop cooking. Close door rmly.
The interior microwave oven light should turn off.
3. Press START. Microwave oven should begin cooking, and
the microwave oven interior light should be on.
Let microwave oven complete cooking time. A tone will
sound at the end of the cooking time, and the microwave
oven will shut off.
4. Open microwave oven door and slowly remove container.
Water in container should be hot.
If You Need Assistance or Service:
Please reference the “Warranty” section of the Use
andCareGuide.