Owners Manual
Table Of Contents
- BUILT-IN OVEN SAFETY
- Built-In Oven Safety
- OVEN MAINTENANCE AND CARE
- General Cleaning
- Self-Cleaning Cycle
- Steam Clean (on some models)
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- INSTALLATIONS
- Prepare Built-In Oven
- Remove Oven Door(s)
- Positioning Oven Feet for Multiple Cabinet Cutout Heights
- Make Electrical Connection
- Install Oven
- Replace Oven Door(s)
- Complete Installation
- SÉCURITÉ DU FOUR ENCASTRÉ
- Sécurité du four encastré
- ENTRETIEN ET RÉPARATION DU FOUR
- Nettoyage général
- Programme d’autonettoyage
- Steam Clean (nettoyage à la vapeur) (sur certains modèles)
- INSTRUCTIONS D’INSTALLATION
- SPÉCIFICATIONS
- Outils et pièces
- Exigences d’emplacement
- Spécifications électriques
- INSTALLATION
- Préparer le four encastré
- Enlever la/les porte(s) du four
- Positionner les pieds du four pour des ouvertures de découpe dans l’armoire
- Raccordement électrique
- Installation du four
- Réinstallation de la/des porte(s) du four
- Achever l’installation
19
5. The bottom vent and bottom vent shield are shipped in the
foam packing at the top of the oven.
Long bottom vent trims are used when the oven is installed
with the feet in the tall position. Please contact service for one
to be shipped to you free of charge.
� Align vent tab (B) with oven frame (A) as shown.
� Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the vent tab (B), fasten the vent securely to the oven frame
(A).
A. Oven frame
B. Vent tab
C. #8-18 x 3/8" (9.5 mm)
screws
6. After the bottom vent shield is installed.
� Align the Bottom vent tab (B) with the oven frame (A) as
shown.
� Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the vent tab (B), align the top of the bottom vent tab (B) to
the Hinge receiver (D) as shown.
� Fasten the bottom vent securely to the oven frame (A).
A. Oven frame
B. Vent tab
C. #8-18 x 3/8" (9.5 mm)
screw
D. Hinge receiver
7. Replace the oven racks.
8. Replace the oven door. See the “Replace Oven Door(s)”
section.
9. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
“Prepare Built-In Oven” section.
10. Repeat for lower oven door.
IMPORTANT: For proper oven operation, check that the gap
between bottom of the door and bottom vent is at least 1/4"
(6.4 mm)
11. Reconnect power.
12. The display panel will light and boot up.
13. If the display panel does not light, refer the Warranty.
C
B
A
A
C
B
D
B